Installation
Electrical connection
230 V - 50 Hz
General
When the appliance does not have a
connecting cable and plug, then it may be
connected to the mains only by an approved
installer.
Note:
The power rating and required mains voltage
are shown on the rating plate at the back of
the appliance. Connection should take place
according to national and local regulations.
If the input of the appliance exceeds 3 kW, the
appliance has to be connected to an outlet
with a rated current exceeding 13 Amp.
Technical data
Types 60 cm 45 cm
Connected load kW 2,0 2,0
Dimensions
Max. height mm 870 870
Min. height mm 820 820
Width mm 596 446
Depth mm 550 550
Door panel:
Max. height mm 720 720
Min. height mm 650 650
Width mm 598 448
Plinth:
Max. height mm 170 170
Min. height mm 100 100
What else you should watch out for
■ Always fit tap, drainage and earthed
plug/wall socket within reach.
■ Make sure that the skirting-board can be
removed. It must be possible to take the
dishwasher out of its recess for
maintenance or repair work.
■ Connect water inlet hose/aquastop to a
self-venting water tap with a 3/4" screw
connection.
Make sure that no dirt remains in a newly-
installed water pipe.
■ The dishwasher may be connected either
to a cold-water tap or to a hot-water tap
(maximum 60 °C).
If you connect the dishwasher to a hot-
water tap, the washing time will be
reduced by about twenty minutes.
However, the dishwasher will wash less
efficiently. The 45 °C programme will
therefore be carried out at a slightly higher
temperature.
■ Do not drill holes in the door or walls. The
dishwasher could be damaged beyond
repair.
Building-in
Remove the wooden platform on which the
machine is standing by unscrewing the
screws.
Fix the adjustable feet with the lock nuts
beneath the side panels of the machine.
30
INSTALLATION
