29
28
INSTALLATION GUIDE
Electrical connection
230 V -50 Hz
■ The appliance should always be earthed.
Use good quality cable for connecting e.g.
H05RRF, 1,5 or 2,5 mm
2
, with 3 or 5 cores,
depending on the regulations.
With following colour code:
brown = phase L
blue = phase N
green/yellow = earth ( )
black= neutral or phase
Depending upon the wiring diagram, you
can use the black cores for neutral or a
phase.
The cable must have a plug suitable for a
nominal load of at least 15 A.
If you want to make a fixed connection,
ensure that a multi-pole switch with a
distance between contacts of 3 mm is
installed in the supply cable.
Wiring diagrams
■ There is a label showing the wiring
diagrams on the underside of the appliance.
Disposal of packaging and
appliance
The appliance's packaging is recyclable. The
following may be used:
- cardboard;
- polyethylene film (PE);
- CFC-free polystyrene (PS rigid foam).
Dispose of these materials responsibly and in
accordance with government regulations.
The government can also provide information
about the responsible disposal of discarded
domestic appliances.
Building in dimensions
Saw the opening in the worktop. This should
be done very accurately (see ill.). Also saw
out any partitions that may be present.
Installation
General
When the appliance does not have a
connecting cable and plug, then it may be
connected to the mains only by an approved
installer.
After installation the wall socket and plug
must be accessible at all times.
Please note:
The power rating and required mains voltage
are shown on the rating plate at the back of
the oven. Connection should take place
according to national and local regulations.
The seal between the hob and the work
surface must be moisture-proof. The work
surface must be absolutely level, as must the
hob of course!
■ If the work surface is tiled it could be
necessary to use liquid silicone rubber
instead of the sealing strip.
■ If the hob is enclosed between the back
and side panels a minimum distance of
40 mm from these panels should be
observed.
■ Tighten the mounting clips equally.
■ A hob should preferably not be positioned
immediately above a refrigerator or freezer
built-in below the worktop. If the hob has to
be fitted above a refrigerator or freezer,
ensure that the hob is well insulated.
INSTALLATION GUIDE
