Manual Peg Perego Tak (page 14 of 64) (English, German, Dutch, Danish, French, Italian, Portuguese, Turkish, Spanish, Finnish)

769186

Zoom out

Zoom in

1/64

- 14 -

_ WARNING Never leave the child

unattended.

_ Always apply the brake when

stationary and when loading or

unloading children.

_ Do not insert fingers into the

mechanisms.

_ Be careful not to hurt the child

when adjusting the mechanisms

(handlebar, backrest … ).

_ Any load applied to the handle and/

or the backrest and/or laterally to

the product can compromise the

stability of the product.

_ Do not load the baskets over 5

Kg. Do not put weight in the cup

holder (if present) in excess of

those indicated on the cup holders

themselves and never hot drinks. Do

not put loads of more than 0.2 Kg in

the hood pockets (if present).

_ Do not use the product near to

stairs or steps, heat sources, naked

flames or dangerous objects within

reach of the child.

_ Only replacement parts supplied or

recommended by the manufacturer/

distributor shall be used.

_ WARNING This product is not

suitable for running or skating.

_ WARNING Do not add any

mattress are not approved by the

manufacturer.

_ Do not use accessories which are

not approved by the manufacturer.

The images referring to the textile details may

differ from the collection purchased.

For more information, consult our website:

www.pegperego.com

INSTRUCTIONS

OPENING: Before opening the frame, remove (without

using blades) any die-cut cardboard.

To unfold the stroller, push the lever on the handlebar to

the right (arrow 1) and, at the same time, push the other

lever (also on the handlebar) to the right (arrow 2).

Lift the stroller upwards (arrow 3).

WARNING: the chassis is properly engaged when

you hear the clicking sound. Check both sides to

ensure it is fully opened and duly fastened (arrow 4).

2 ATTACHING THE FRONT WHEELS: to assemble the

front wheels, insert them into the housings until you

hear the click.

3 BASKET: To the rear of the stroller, fasten the basket’s

4 eyelets to the 4 buttons on the product’s frame

(fig_a) and fasten the central Velcro to the stroller’s

upper tube alone (fig_b).

4 Fastening the front part of the basket:

fasten the upper basket eyelet to the button on each

side of the frame (fig_a) and then fasten the central

Velcro, sliding it through the tube placed under the

footrest (fig_b).

WARNING: if you do not hook the basket on

correctly, as shown, the basket will be unable to

support the weight of loads placed in it.

5 SWIVELLING OR LOCKED FRONT WHEELS: for swivelling

wheels, lift the lever (fig_a).

Lower the lever to lock the front wheels (Fig. b).

6 BRAKE: To set the brake on the stroller, lower the lever

on the rear wheel unit with your foot. To release the

brake, lift the lever. When stationary, always apply the

brake.

7 FOLDING: to fold the stroller, move the lever on the

handlebar to the right (arrow 1) and, at the same time,

pull the other lever (also on the handlebar) to the right

(arrow 2) and push the stroller down (arrow 3).

When folded, the stroller will stand upright.

ATTACHING THE BUMPER BAR: the stroller must be folded.

Position the bumper bar as shown in the picture and

attach it to the studs on the side. Lastly, pull it towards you

to attach it correctly, until it clicks. Repeat on both sides.

Take care to avoid trapping any fabric elements,

because this prevents the product from working

correctly.

9 REMOVING THE FRONT WHEELS: if you need to remove

them, press the button (arrow 1) and remove them

(arrow 2) .

10 HOOD: To assemble the hood, insert the attachments

into the highest housings until they click (fig_a).

11 Attach the hood’s 2 buttons to the stroller sack, on the

side (fig_b).

At the back, attach the hood’s two buttons to the

stroller’s backrest (arrows 1 and 2) and, lastly, pucker it

by pulling the drawstring upwards (fig_c).

12 The hood can be adjusted into several positions by

simply pulling it backwards or forwards.

The hood includes a loop to be used to hang your child's

favourite toy.

13 BUMPER BAR: it can be extended by pressing the

buttons on the sides and pulling it outwards (fig_a).

It can be opened on one side only or removed

completely, so it is easier for the child to enter and

exit (fig_b).

WARNING: The bumper bar is not designed to:

- support the child’s weight;

- lift the seat with the child in it;

The bumper bar does not replace the seat’s safety belt.

14 To re-assemble the bumper bar, insert it in the

specific housings in the sequence shown.

15 FIVE POINT SAFETY HARNESS: to fasten it, push the two

waist strap buckles (with the shoulder straps attached

– arrow_a) into the leg divider until they click into

place (arrow_b). To unfasten it, press the round button

in the centre of the buckle (arrow_c) and pull the waist

straps out (arrow_d).

16 To tighten the waist strap, pull on both sides in the

direction of the arrow (arrow_a).

17 It is possible to set the safety harness at 3 different

heights, depending on how tall the child is. As the

child gets bigger, the harness must be moved to a

higher position.

18 To adjust the height, slip the belts through the eyelet

in the fabric and position them in the most suitable

eyelet.

19 ADJUSTING THE LEG REST: The leg rest can be

extended - simply pull it towards you to extend it and

push it inwards to reposition it.

BACKREST ADJUSTMENT: to adjust the backrest, lift the

handle (fig_a) and recline it to the desired position. The

backrest can be adjusted into different positions (fig_b).

21 REMOVING THE LINING: to remove the stroller's lining:

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Peg Perego Tak in the language / languages: English, German, Dutch, Danish, French, Italian, Portuguese, Turkish, Spanish, Finnish as an attachment in your email.

The manual is 1,99 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Peg Perego Tak Manual

Product: