Manual Peg Perego Booklet-Lite (page 15 of 68) (All languages)

626127

Zoom out

Zoom in

1/68

- 15 -

sources, naked flames or dangerous objects within

reach of the child.

_ Only replacement parts supplied or recommended by

the manufacturer/distributor shall be used.

_ WARNING Don't use the rain cover (if present)

on a product without a hood or parasol that can

hold it. Always use the rain cover only under adult

supervision. Don't use the rain cover indoors and

check to ensure the child is not to warm; do not

park the vehicle close to heat sources and keep well

away from the lighted cigarettes. Ensure that the rain

cover is not interfering with any moving parts of the

carriage/stroller. Always remove the rain cover before

folding your carriage/stroller.

_ WARNING This product is not suitable for running or

skating.

_ Always apply the brake when loading or unloading

children.

_ WARNING Do not add any mattress are not approved

by the manufacturer.

COMPONENTS OF THE ITEM

Check the contents of the packaging and if you have

any complaints please contact the Assistance Service.

_ Booklet / Booklet Lite : basket; 2 back wheels with

brake lock, back wheel axis, 2 front wheels, handlebar,

hood.

INSTRUCTIONS

1 OPENING: Before opening the frame, remove (without

using blades) any die-cut cardboard.

WARNING:

_ DO NOT PULL OR FORCE THE FASTENER BEYOND ITS

LIMIT.

_ DO NOT USE THE FASTENER AS A CARRY HANDLE OR

TO CARRY WEIGHTS.

DO NOT HANG BAGS OR OTHER ACCESSORIES TO THIS

FEATURE.

Press down the side fastener, hold the upper section of

the handle and rotate it towards you until the frame is fully

opened (fig_a). Open frame (fig_b).

The frame is properly opened when the attachment on the

base clicks into place, as shown.

2 FITTING THE WHEELS: Slot the uprights into the rear

wheel crosspiece (fig_a), ensuring that it is facing the

right way, then push the rear wheels on and make

sure that they click into place (fig_b).

To mount the

front wheels, fit them into the uprights until they lock into

place (fig_c).

3 ATTACHING THE MAIN HANDLE: if the handle tube

faces upwards, align it with the stroller (Fig_a).

Fasten the handle to the frame as shown in the figure

(Fig_b).

To complete the operation, press the two side buttons

on the handle (Fig_c) to ensure the handle pushes in

all the way, until it clicks into place (Fig_d).

4 FITTING THE BASKET: if lowered, lift the basket tube to

the horizontal position. Press the silver buttons under

the metal basket tube located at the back of the stroller

(fig_a) and remove the metal tube (fig_b). Thread the tube

through the fabric loop on the back of the basket, making

sure that the two silver buttons are facing downward

(fig_c). Re-attach the tube to the housings (fig_d).

5 Secure the two upper basket vinyl eyelets to the two grey

buttons on either side of the metal tube housing. Please

note that the eyelets open (fig_e). Remove the cardboard

from the lower rear bar.

IMPORTANT!

Secure the two lower basket vinyl eyelets

to the two grey buttons on the top of the lower rear bar.

Please note that the eyelets open (fig_f).

WARNING!

If this operation is not performed correctly,

the basket will not properly hold the weight.

Attach the basket tabs to the grey buttons on the front of

the frame (figure).

REFER TO OUR INSTALLATION INSTRUCTIONS VIDEO AT:

WWW.PEGPEREGO.COM

6 Attach the back of the hood with Velcro (fig_a), slide

the hood attachments into their slots (fig_b), fasten

the elastic straps to the buttons placed inside the

handle (fig_c), and button the sides of the hood to

the frame (fig_d).

7 FIXED OR SWIVELING FRONT WHEELS: Lift the levers

to prevent the wheels from swiveling (fig_a) and

lower them to allow the wheels to swivel (fig_b). On

uneven surfaces, the wheels should be set to their

fixed position.

8 BRAKE: Press the lever down to apply the brake on the

chassis and lift it to release the brake.

9 ADJUSTABLE HANDLEBAR: To adjust the height of the

handlebar, press both of the side buttons at the same

time (fig_a) and swing it into the desired position

(fig_b), then release the buttons.

10 FOOTREST: before adjusting the foot rest, ensure its

cover is accurately fitted; if it isn’t, fit it accordingly. To

lower the footrest push the two levers downwards and

then push the footrest downwards (fig_a); to raise the

footrest lift it upwards (fig_b).

11 HOOD: the hood has a sun canopy. Pull it out from

inside the hood (fig_a).

The hood has an eyelet from which to hang the baby's

favourite toy (fig_b) and a clear window which allows

you to see your child (fig_c). To lift it, remove the

elastic from around the button. You can unfasten the

Velcro strap and roll up the back of the hood, fixing

it up with the elastic, for increased ventilation when

using the stroller with the backrest lowered.

12 ADJUSTING THE BACKREST: to lower the backrest,

press the clip and the backrest will move down to the

desired position.

To raise the backrest, press the clip and lift the

backrest to the desired height.

13 FIVE POINT SAFETY HARNESS: To fasten it, push the

two waist strap buckles (with the shoulder straps

attached – arrow_a) into the leg divider until they click

into place (arrow_b). To unfasten it, press the round

button in the centre of the buckle (arrow_c) and pull

the waist straps out (arrow_d).

14 To tighten the waist strap, pull on both sides in the

direction of the arrow (arrow_a). To loosen it, move it

in the opposite direction.

15 Before adjusting the height of the safety harness

remove the shoulder pads (fig_a). To adjust the

height, slip the belts through the eyelet in the fabric

(fig_b) and position them in the most suitable eyelet.

16 FOLDING UP: To fold the stroller, it is best to set the

front wheels to their fixed position and close the

hood (if fitted). Place the handle as shown in the figure

(fig_a).

Pull the inside handle on the base (fig_b) and lift it (fig_c);

the handle will drop forward until the frame is closed.

17 To close correctly, check the side hook is inserted

(fig_a). If not automatically locked, compress the

chassis slightly. When folded, the stroller will free

standing (fig_b).

18 For greater compactness, it is possible to remove the

wheels.

To remove the rear wheels: pull the pivot outwards and

remove the wheel as shown in the figure (fig_a).

To remove the front wheels: press the tab as shown, and

remove the wheel (fig_b).

TRANSPORT: the stroller can be carried comfortably

locking the front wheels and grasping the main handle

(fig_c).

19 REMOVABLE ITEMS: to remove the hood, take the

elastic off from the buttons on the inside of the

handlebar (fig_a), detach the press studs the sides of

the chassis (fig_b), detach the Velcro strip from the

backrest (fig_c) and remove the attachments of the

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Peg Perego Booklet-Lite in the language / languages: All languages as an attachment in your email.

The manual is 5,49 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Peg Perego Booklet-Lite Manual

Product: