783298

Peaq PSB 400 Manual

11
Zoom out
Zoom in
Previous page
1/87
Next page
ENGLISH
11
• Place the cord and, if necessary, an appropriate
extension cable in such away that pulling or
tripping over it is impossible. Do not allow the
cord to hang down within easy reach.
• Do not jam, bend or pull the cord over sharp
edges.
• The power supply is used as the disconnect
device; the disconnect device shall remain
readily operable. To completely disconnect the
power input, disconnect the power supply.
• The product may not function properly or
not react to the operation of any control due
to electrostatic discharge. Switch o and
disconnect the product; reconnect after a few
seconds.
• Protect the supply cord from being walked on
or pinched particularly at the plug, convenience
receptacles and the point where it exits from
the product.
• Never touch the power supply with wet hands.
• Disconnect the power supply in case of faults
during use, during lightening storms, before
cleaning and when not using the product for a
longer period of time.
• Danger! Before cleaning, switch the product
o and disconnect the power supply from the
socket.
• When the product has reached the end of its
service life, make it defective by disconnecting
the plug from the socket and cutting the cord
in two.
• Caution! There is danger of explosion from
improper replacement of the batteries. Replace
batteries only with the same or equivalent type
of battery.
• Always change the entire battery pack. Do not
mix old and new batteries, or batteries with
dierent charge state.
• Make sure the batteries are correctly inserted.
Observe the polarity (+) plus / (-) negative
on the battery and the housing. Improperly
inserted batteries can lead to leakage or, in
extreme cases, a fire or an explosion.
• Remove used batteries. Remove the batteries
if you know that the product will not be used
for a longer period of time. Otherwise, the
batteries could leak and cause damage.
• If the batteries leak, remove them with a cloth
and dispose of them accordingly. Prevent
battery fluid from coming into contact with skin
and eyes. If you do get battery fluid in your
eyes, flush them thoroughly with lots of water
and consult a physician immediately. If battery
fluid comes into contact with your skin, wash
the aected area with lots of water and soap.
• When installing the device, leave sucient
space for ventilation. Do not install in
bookcases, built-in cabinets or the like.
• Do not impede ventilation by covering the
ventilation openings with items, such as
newspapers, table-cloths, curtains, etc. Do
not insert any objects.
• Warning! Do not ingest the battery, Chemical
Burn Hazard.
• Keep new and used batteries away from
children.
• If you think batteries might have been
swallowed or placed inside any part of the
body, seek immediate medical attention.
• If the battery compartment does not close
securely, stop using the product and keep it
away from children.
• Never expose batteries to excessive heat (e.g.
bright sun, fire), and never throw them into fire.
The batteries could explode.
• Remove the batteries from the product before
disposal.
• If the battery is swallowed, it can cause severe
internal burns in just 2 hours and can lead to
death.
… 11 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Peaq PSB 400 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Peaq PSB 400 in the language / languages: English, German, Dutch, French, Italian, Polish, Portuguese, Swedish, Turkish, Spanish as an attachment in your email.

The manual is 4.65 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info