598069
6
Zoom out
Zoom in
Previous page
1/51
Next page
Assembly
10
Lift the empty styrofoam blocks and the body of the
machine out of the box.
Align the machine with the front table edge in such a
way that the machine slightly slopes to the back.
At each end fit the feeding eyelet supports underneath
the needle bed. The illustration shows the left half of
the needle bed as seen from the back. Look at this
backview of the needle bed. You will see four screws
that fit into round plastic pins. Insert the feeding eyelet
support between the second and the third screw, at
the same time depressing the small latch on the
feeding eyelet support. Make sure the support clicks
into place. t
11
From the side insert the row counter into its
support-rail exactly as shown in the illustration.
If this has been done correctly, the row counter will not
touch the table when the machine is in its correct
position.
Now fasten the needle bed to the table edge using the
two clamps.
4
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Passap Swissknitter at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Passap Swissknitter in the language / languages: English as an attachment in your email.

The manual is 1,71 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info