142 CZ
Kzamezení nebo redukci deformací vznikajících během tvrdnutí materiálu je dobré obrobky před
svařováním upevnit do přípravku. Musí se zamezit vyztužení svařované struktury, aby nedocházelo
kprasknutí svaru. Tyto obtíže lze redukovat, pokud existuje možnost obrobek otočit tak, aby bylo možno
svařování provést ve dvou krocích protichůdným směrem.
Svary na vnějším rohu
Příprava tohoto druhu je velmi jednoduchá (obr. W, X).
W X
Usilnějších materiálů však již nemá význam. Vtomto případě je lepší svar připravit tak, jak je popsáno
níže, kdy je hrana jedné zdesek zkosená (obr. Y).
Y
Koutové svary
Koutový svar vzniká, pokud jsou obrobky navzájem kolmé. Svar by měl mít tvar rovnostranného
trojúhelníku s mírným žlábkem (obr. Z, AA).
Svary na vnitřním rohu
Příprava tohoto druhu je velmi jednoduchá a provádí se do tlouštěk 5 mm. Rozměr „d“ se musí
redukovat na minimum a vkaždém případě musí být menší než 2 mm (obr. Z).
Z
AA
Usilnějších materiálů však již nemá význam. Vtomto případě je lepší svar připravit tak, jak je znázorněno
na obrázku Y, kdy je hrana jedné zdesek zkosená.