NL/BE 117
Stekend lassen Slepend lassen
Inbranden kleine grote
Lasnaadbreedte grote kleine
Lasrups vlakke hoge
Lasnaadfout grote kleine
AANWIJZING: Welke lasmethode geschikter is, beslist u zelf nadat u een proefstuk hebt gelast.
AANWIJZING: Nadat de elektrode volledig is versleten, moet deze worden vervangen.
zWIG/TIG-lassen
Volg de gegevens over uw WIG-toorts voor WIG-/TIG-lassen. De WIG/TIG/modus kan weer worden
geactiveerd, zoals hieronder is beschreven bij “Lasmethode kiezen”.
AANWIJZING: Alle op de volgende schetsen getoonde waarden zijn alleen voorbeelden en
vormen geen advies voor bepaalde lasparameters.
Schets 8
Bij de selectie van de TIG-methode kunt u de lasstroom door te draaien aan de draaischakelaar voor de
lasstroominstelling 13 (hierna schakelaar 13 genoemd) instellen. Bovendien kan de functie ANTI STICK
door te drukken op en te draaien aan schakelaar 13 worden geactiveerd. [Schets 8] ANTI STICK
voorkomt dat de elektroden aan het werkstuk blijven kleven. Door te draaien aan de schakelaar voor het
instellen van de spanning 12 kan de waarde voor UP TIME worden ingesteld. Deze geeft aan hoe snel
de stroom bij aanvang van de laswerkzaamheden wordt opgestart. Een hogere waarde betekent
langzamer opstarten.