754142

Parkside PKZ 1000 A1 - IAN 344906 Manual

22
Zoom out
Zoom in
Previous page
1/102
Next page
18 GB/IE
4. The load chain should be greased before use.
5. The brake surfaces must not be greased. The brake must be kept dry
6. Make sure that the load chain has no knots. If there are knots in the load chain, these
must be removed before use.
7. Make sure the load chain is hung on the chain pulley before each use.
8. When pulling the hand chain, stand in the same position and angle as the drive wheel.
Do not pull at an oblique angle. A secure posture is necessary.
9. Do not lift the load so that it is above any persons. Do not allow any persons to walk
underneath the load. If you wish to lift a load, please warn anyone in the surrounding
area.
10. Do not lift any persons with the chain hoist.
11. The load must be held firmly in the hook. Try not to lift the load with the point of the
load hook.
12. Pull the hand chain evenly, to avoid thrusts or entanglements.
13. If the chain is barred or cannot be pulled further, please stop. Examine and resolve
the problem. Do not attempt to use force on the chain hoist. Do not leave the load
hanging in the air.
14. Please do not lower the load further than the usable length of the chain. If the chain
between the chain wheel and the chain pulley is pulled too taught, this can cause
damage.
15. Do not allow the load to come into contact with the chain hoist, otherwise free rotation
will be blocked, which could cause damage, knots in the chain or barred wheels.
16. Regular checks and maintenance should be carried out. All damaged or faulty parts
must be exchanged by an expert.
17. The chain hoist functioning in both “with load” as well as “without load” modes must
be thoroughly and adequately checked.
18. Make sure the load weight is smaller than the stated weight of the chain hoist. If in
doubt, do not use the chain hoist.
19. Never overload the chain hoist.
20. Safety procedures, examinations and greasing should be carried out before and
during operation. The chain hoist should only be used if it is in proper working order.
21. Always make sure the chain is vertical and straight, and there are no knots.
22. Never pull the hand chain and the load chain at an oblique angle.
23. Do not use the chain block in an explosive environment or damp rooms.
24. Examine the load chain (1), hand chain (2), fastening hook (3), load hook (4), load
pin (5), drive wheel (6), and latch lock (7) for defects, especially after longer periods
of standstill.
25. Adjust the hand chain (2) so that the point of chain reversal of the hand chain (2) is at
a height of between 500 and 1000 mm above the ground.
26. Pay attention to any defects which may have occurred during use. If there are
noticeable problems, immediately stop the chain block from operating.
… 22 …


Need help? Post your question in this forum.

Forumrules
1

Forum

parkside-pkz-1000-a1---ian-344906

Reset search

  • Miért nincs magyar nyelvu kezelési utasítás - ezt a törvény eloírja!Kérem 3 napon belül szíveskedjenek az email címemre megküldeni, ellenkezo esetben a fogyasztó védelemnél bejelentést teszek.
    Köszönöm:
    Pálházi Sándor
    splhzi@yahoo.com Submitted on 19-7-2021 at 13:06

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Parkside PKZ 1000 A1 - IAN 344906 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Parkside PKZ 1000 A1 - IAN 344906 in the language / languages: English, German, Dutch, French, Polish as an attachment in your email.

The manual is 3,74 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info