595331

Parkside PHLG 2000 C2 - IAN 103976 Manual

7
Zoom out
Zoom in
Previous page
1/29
Next page
7 GB/IE
General safety advice
moving parts of the device. Damaged
or tangled mains leads increase the risk of
electric shock.
Use a residual current device (RCD)
for protection if operating the electri-
cal power tool in a moist environment
is unavoidable. The use of an RCD reduces
the risk of electric shock.
Do not use an electrical power tool if
its switch is defective. An electrical power
tool that can no longer be switched on and off
is dangerous and must be repaired.
General instructions
This appliance can be used by children aged
from 8 years and above and persons with re-
duced physical, sensory or mental capabilities
or lack of experience and knowledge if they have
been given supervision or instruction concerning
use of the appliance in a safe way and under-
stand the hazards involved. Children shall not p
lay
with the appliance. Cleaning and user mainte-
nance shall not be made by children without
supervision.
If the mains power cable of this appliance is
damaged, it must be replaced by the manufac-
turer or its service department, or a similarly
qualified person to prevent hazards.
Instructions for hot air blower
A fire may result if the appliance is not used
with care.
Be careful when using the appliance in places
where there are combustible materials.
Do not apply to the same place for a long time.
Do not use in presence of an explosive atmosphere.
Be aware that heat may be conducted to com-
bustible materials that are out of sight.
Place the appliance on its stand after use and
allow it to cool down before storage (see Ill. D).
Do not leave the appliance unattended when it
is switched on.
Supervise children. Ensure that children do
not play with the hot air blower.
Supplementary Instructions
ATTENTION! To avoid the danger of injury,
burning and dangers to your health:
If danger arises, pull the mains plug immediate-
ly out of the mains socket.
DANGER OF PERSONAL INJURY!
Never use the appliance as a hair dryer.
Do not direct the heat flow at persons
or animals.
Do not look directly into the opening of the heat
nozzle
3
.
DANGER OF BURNS! Do not touch the hot
nozzle. Wear protective gloves.
Wear protective glasses.
DANGER OF FIRE AND EXPLOSION!
The appliance develops very high temperatures.
If the device is not used carefully, it can give
rise to increased risk of fire or explosion.
Do not work in the vicinity of easily ignitable
gases or materials. Heating of plastics, paints,
varnishes etc. can lead to the creation of gases
that are hazardous to health. Make sure you
always have adequate ventilation.
When taking a break from your work, before
carrying out any tasks on the device itself (e.g.
changing the nozzle) or when you are not
using the device, always pull the mains plug
out of the mains socket.
Maintain a distance between the jet outlet
nozzle and the workpiece or the surface being
heated. An air blockage could lead to over-
heating of the appliance.
Pay heed to the direct working area and also
to its surroundings. The heat produced could
reach to inflammable articles located out of the
visible area.
Always keep the device clean, dry and free
of oil or grease.
Never use the device for a purpose for which it
was not intended.
Introduction / General safety advice
… 7 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Parkside PHLG 2000 C2 - IAN 103976 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Parkside PHLG 2000 C2 - IAN 103976 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 0,83 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info