762962

Parkside PHDB 4 C3 - IAN 327193 Manual

38
Zoom out
Zoom in
Previous page
1/128
Next page
32 GB/IE
17. Troubleshooting
m WARNING
Risk of injury due to accidental starting of the appliance.
• Before working on the appliance, turn the On/Off switch (19) to “OFF” and pull off the spark plug connector (24).
m WARNING
Risk of burns!
• Do not touch the hot exhaust silencer, cylinder or cooling fins.
ATTENTION
• If the fault cannot be remedied, the appliance must be checked by customer service.
Fault Possible cause Remedy
Engine cannot be started Automatic oil switch-off activated. Check oil level, add engine oil.
Soot deposit on spark plug Clean or replace spark plug.
No fuel Add fuel.
Spark plug connector is disconnected Connect the spark plug connector to the spark plug
Spark plug connector is damaged Contact Customer Service
Ignition does not work Contact Customer Service
Engine is difficult to start Out-of-date fuel or water in fuel Drain fuel and fill with new fuel.
Spark plug does not produce an ignition spark Contact Customer Service
Carburettor incorrectly adjusted Contact Customer Service
Engine has too little power
and vibrates excessively
Contaminated air filter Clean the air filter
Engine dies during opera-
tion
No fuel Top up with fuel
Engine loses power during
operation
Engine speed is too low Operate the trigger slower. If the fault persists, contact
Customer Service.
Appliance does not gener-
ate sufficient pressure
Nominal speed of the engine too low. Check the nominal speed of the engine;
contact Customer Service
Low-pressure nozzle is fitted. Fit high-pressure nozzle.
Nozzle blocked/eroded. Clean/replace nozzle
Intake filter contaminated. Clean intake filter
Air in the system. Bleed the appliance (see “Use”).
Water supply quantity too low. Check water supply
Supply lines to high-pressure pump leaking or
blocked.
Check all supply lines to the high-pressure pump. Con-
tact Customer Service.
Pump is defective Contact Customer Service
Appliance is leaking,
water dripping from under
appliance
The high-pressure pump is leaking Max. permissible is 3 drops per minute. For more serious
leaks, have the appliance checked by customer service.
Cleaning agent is not
drawn in
High-pressure nozzle is fitted. Fit low-pressure nozzle
Cleaning agent hose leaking or blocked. Inspect/clean cleaning agent hose
… 38 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Parkside PHDB 4 C3 - IAN 327193 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Parkside PHDB 4 C3 - IAN 327193 in the language / languages: English, German, Dutch, French, Polish as an attachment in your email.

The manual is 6,59 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info