796077
13
Zoom out
Zoom in
Previous page
1/132
Next page
PDSSAP 20-Li B2
8 GBIE
Inserting/removing the battery pack
Inserting the battery pack
Set the rotation direction switch2 to the middle
position (lock). Snap the battery pack8 into
the handle.
Removing the battery pack
Press the release button9 and remove the
battery pack8.
Checking the battery charge level
Press the battery charge level button w to
check the charge level of the battery. The
status/remaining charge will be shown on
the battery display LED q as follows:
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery
Fitting the belt clip
Loosen the fixing screw 3a using a standard
Phillips screwdriver (not supplied).
Hold the corresponding hole of the belt clip 3
over that of the screw thread.
Tighten the fixing screw 3a .
Switching on/off
Switching on
Press and hold the ON/OFF switch 7 to start
the tool.
The LED work light 4 lights up when the ON/
OFF switch7 is pressed lightly or fully.
This provides illumination of the work area in
poor lighting conditions.
Switching off
Release the ON/OFF switch 7 to switch off the
appliance.
Setting/preselecting the rotation
speed/tightening torque
Press the torque preselection button6 to select
the required torque incrementally. The selected
torque is shown on the torque display5.
Pressing the ON/OFF switch7 lightly yields a
low speed. Increasing the pressure increases
the speed/tightening torque.
The tightening torque depends on the selected
speed/torque preselection and impact duration.
NOTE
When tightening wheel nuts, however, the
smallest torque setting must be selected to
avoid over-tightening.
The integrated motor brake ensures rapid
stoppage.
ATTENTION!
The tightening torque actually attained must
always be checked with a torque wrench!
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Parkside PDSSAP 20-Li B2 - IAN 364886 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Parkside PDSSAP 20-Li B2 - IAN 364886 in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Spanish as an attachment in your email.

The manual is 1.92 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info