764045
11
Zoom out
Zoom in
Previous page
1/112
Next page
PBLG 52 A18 GBIE
Starting when the engine is hot
(The appliance has been turned off for less than 15–20 minutes)
Set the On/Off switch0 to “I”.
The choket does not need to be pulled out to start a warm motor.
Press the appliance against the floor with your left hand on the
frame1 (ATTENTION! Do not use your foot!). With your right hand
on the pull start z, pull it slowly until you feel resistance.
ATTENTION!
Always pull the pull startz straight out. Hold the handle of the pull
startz firmly when the pull startz retracts. Do not allow the pull
startz to whip back.
Now pull quickly on the pull startz. The appliance should start after
1–2 pulls. If the appliance has still not started after 6 pulls, repeat the
process as described in “Starting when the engine is cold”.
Parking throttle/throttle lever lock
Press the throttle9 halfway down and then push down the throttle
lock .
Now release the throttle9 and the throttle lock .
The throttle9 is now locked.
NOTE
When the throttle lever lock is actuated, the unit does not run in full
throttle position!
Turning the engine off
Emergency stop sequence
If the appliance needs to be stopped immediately, turn the On/off
switch0 to “0”.
Normal sequence
Release the throttle9. The engine idles. Then move the On/Off
switch0 to “0”.
Basic working techniques
Make sure that you are familiar with the appliance before starting work.
WARNING!
WARNING! Risk of flying objects. Always wear goggles. Flying
stones, debris, etc. could hit your eyes and cause serious injury or
blindness. Maintain a safe distance. Children, animals, spectators and
helpers should remain outside a safety zone of 15m. Switch off the
appliance immediately if anyone approaches.
Do not use the appliance if the exhaust opening on the engine cover is
obstructed by a wall and/or other objects. Otherwise, the appliance
could be damaged. Ensure that a distance of at least 50 cm to other
objects is always maintained during operation.
The leaf blower is portable and is carried during operation on the
shoulders by means of a belt. It is controlled with the right hand using
the handle on the pipe.
The speed of the air jet is controlled with the throttle. Adjust the speed to
the respective application.
Make sure that the air inlet is not blocked, for example, by leaves or
dirt. A blocked air inlet reduces the blowing power and increases the
working temperature of the engine, which can lead to engine failure.
If necessary, switch off the engine and remove any foreign bodies.
Pay attention to the wind direction. It is easier to work with the wind
(at your back).
The leaf blower should not be used to move large piles of leaves, as
this is very time-consuming and causes unnecessary noise.
Assume a safe working position with a firm stand.
After finishing work, the machine must be stored upright.
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Parkside PBLG 52 A1 - IAN 354733 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Parkside PBLG 52 A1 - IAN 354733 in the language / languages: English, German, Dutch, Danish, French, Polish, Spanish as an attachment in your email.

The manual is 3,03 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info