744945
39
Zoom out
Zoom in
Previous page
1/44
Next page
39 GB
General safety instructions … / Before initial use / Preparations for use
Always observe all the safety advice attached
to the compressor.
Make sure that the compressor intake opening
is never blocked and the airflow is never hin-
dered.
Clean the suction filter with a cloth when it is
dirty. Switch off the device and pull the plug
from the socket to prevent it from being acci-
dentally switched on.
Do not allow yourself to become distracted while
working with the device.
General safety information
for electrical devices
Never connect the device to a residual current
(FI) protective switch.
Protect yourself against electric shock. As you
are working, avoid touching grounded parts
(e.g. refrigerator, water supply pipes etc.).
DANGER! Avoid contact with live lines. This
device is not insulated against electric shock.
Check extension and power supply cables reg-
ularly. Replace any faulty cables with new ones
immediately.
If the mains power cable of this device is dam-
aged, it has to be replaced by the manufacturer
or its service department or a similarly qualified
person in order to avoid hazards.
Store the device in a dry environment when it is
not being used over a longer period.
Make sure that the connection cable does not
hang over a corner or be stretched; otherwise
there is a risk of injury.
Do not use the mains lead for any purpose for
which it was not intended, e.g. to carry the
product, to hang it up or to pull the mains plug
out of the mains socket.
Never pull on the mains cable to remove the
mains plug from the socket.
Never use electrical tool in damp or wet envi-
ronments and never expose it to rain or high
humidity.
Never switch on the device in the vicinity of in-
flammable liquids or gases.
If the device is used outdoors, only use exten-
sion cables that are expressly designed for out-
door use.
Product-specific safety
instructions
CAUTION! RISK OF BURNS!
The compressor heats up after ex-
tended operation. Therefore always
use the handle on the device to move it. Never
touch the device itself!
ATTENTION! The casing of the airbrush com-
pressor may become hot during use. Do not
touch hot surfaces in order to prevent burns.
Never leave the device in operation unattended.
Built-up heat generated by the device can be a
source of danger.
Before initial use
Check that all parts of the device are in perfect
condition.
Make sure that the available mains voltage is
compatible with the voltage intended for oper-
ating the compressor.
Note: You will find the intended mains voltage
on the type plate of the device.
Preparations for use
Connecting the airbrush set
Be absolutely certain to disconnect the mains
plug before connecting the airbrush set to the
compressor and release the pressure in the lines
by actuating the vent of the air blow gun
9
.
Use the respective screw connection to connect
the spray stylus
3
with the coiled hose
2
and
the coiled hose to the airbrush connection
1
.
Use the included open-end wrench.
13
(see Ill. A).
Fasten the paint mixing beaker with connection
lid
5
to the spray stylus
3
(see Ill. B).
Insert the mains plug into the mains socket.
General safety instructions for compressed air tools
73868_par_Airbrush_Set_Content_LB2+GB.indd 39 06.07.12 12:26
39


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Parkside IAN 73868 PABK 60 A1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Parkside IAN 73868 PABK 60 A1 in the language / languages: French as an attachment in your email.

The manual is 2,36 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Parkside IAN 73868 PABK 60 A1

Parkside IAN 73868 PABK 60 A1 User Manual - English, German, Dutch - 34 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info