GB/
MT
1. Introduction
Important.
When using the equipment, a few safety
precautions must be observed to avoid injuries
and damage. Please read the complete
operating manual with due care. Keep this
manual in a safe place so that the information is
available at all times. If you give the equipment
to any other person, hand over these operating
instructions as well. We cannot accept any
liability for damage or accidents which arise due
to a failure to follow these instructions and the
safety information.
2. Safety Information
CAUTION
Read all the safety regulations and
instructions. Any errors made in following the
safety regulations and instructions may result in
an electric shock, fire and/or serious injury.
Keep all safety regulations and instructions
in a safe place for future use.
Protect yourself and your environment from
accidents by taking the appropriate
precautionary measures.
■ Do not use the stapler for a purpose for
which it is not designed.
■ Keep air tools safe from children.
■ Never use the equipment when you are not
rested or distracted.
■ Connect the compressed air using a quick-
lock coupling only.
■ Staplers may only be connected to
lines/hoses which do not allow the
maximum permitted pressure of the
equipment to be exceeded by more than
10%. A pressure regulator (pressure
reducer) with a downstream pressure
control valve must be fitted to the
compressed air hose if the pressure is
higher.
■ The operating pressure must be adjusted by
a pressure reducer.
■ When using a pneumatically operated
stapler/nailer, only use the pressure
required for the specific operation to prevent
an unnecessarily high noise level, excessive
wear and consequential faults.
■ Never use oxygen or combustible gases as
a power source. Danger of fire and
explosion.
■ Always disconnect the equipment from the
compressed air source before tackling faults
or starting any maintenance work.
■ Use only genuine spare parts. Repairs may
only be carried out by an authorized agent of
the manufacturer or by an alternative
specialist in accordance with the
specifications contained in the operating
instructions.
■ Wear the necessary protective clothing
when working with the stapler, in particular
safety goggles and protective gloves.
■ Do not exceed the maximum air pressure of
8 bar.
■ Do not direct the connected and loaded
nailer at other people.
■ Do not remove the earthing contact device.
■ Never leave the equipment unattended
when loaded.
■ Never use the equipment if defective.
■ Only use the types of staples/nails specified
in the technical data.
■ The equipment must always be
depressurized after disconnection.
■ Never use the equipment without
staples/nails.
■ Never point an operational stapler directly at
yourself or at any other person.
■ Whilst working with the stapler, hold it in
such a way that your head and body cannot
be injured in case of kickback caused by
disruption of the power supply or by hard
areas of the workpiece.
■ Never trigger the stapler into the open air.
This is important to avoid the hazards of
free-flying staples and of overloading the
appliance.
■ For the purposes of transportation, the
stapler must be disconnected from the
compressed-air system, especially if you are
using a ladder or are adopting an unusual
posture.
43
