18
GB IE
Practical tips
Scrubbing wheels:
Never use a cutting wheel for
scrubbing !
Exert only moderate pressure on the work-
piece. Move the device evenly back and
forth.
A working angle of 30° to 40° achieves
the best results for scrub grinding.
Cutting disc:
Never use a scrubbing wheel
for cutting !
grinding discs may be used.
In general, work with small scrubs. Exert
only moderate pressure on the workpiece.
Always work in the counter-direction. This
ensures that the device is not pushed out of
the cut through lack of control.
Cutting of stone materials:
• It is best to use a diamond cutting disc
to cut stone materials. Make sure in any
case that the cutting disc is suitable and
labelled for your application.
• When cutting stone materials, ensure
• Wear a dust protection mask.
• The device may only be used for dry
cutting/dry grinding.
Information on building statics:
Slits in structural walls are subject to the
standard DIN 1053 Part 1 or country-
be observed without fail. Before begin-
ning work you should ask the structural
engineer, architect or relevant construction
supervisor for advice.
Assembly
Caution! Risk of injury!
space in which to work, and
that you do not endanger other
people.
- All hoods and protective devices
must be assembled properly be-
fore commissioning.
- Disconnect the mains plug be-
fore changing the setting on the
device
Mount additional handgrip
The device must only be op-
erated with the handgrip
mounted.
Screw the additional handgrip (2), de-
pending on the type of work, to the left,
right or above the device using the thread-
ing for the handgrip (4).
Assemble/set protective
hood
Adjust the protective cover such that any
sparks or detached parts cannot hit either
the user or any bystanders.
The protective cover must also be posi-
tioned such that the sparks cannot ignite
