745463
11
Zoom out
Zoom in
Previous page
1/72
Next page
G B I E
1 1
Charging process
Do not expose the battery to
extreme conditions such as
heat and impact. There is a
risk of injury from leaking
electrolyte solution! In case
of contact, rinse with water
or neutraliser and consult a
doctor if contact has occurred
with eyes etc.
Charge the battery only in
dry areas.
There is a risk of injury from
electric shock.
The device may only be powered with
SELV (Safety Extra Low Voltage) as
marked on the device.
Before initial use, charge the battery
installed in the equipment. Do not
charge the battery for several short pe-
riods in succession.
To charge the Li-ion battery integrated
in the appliance, use the battery charg-
er supplied.
In all cases, observe the applicable
safety information as well as the regu-
lations and directions for environmen-
tal protection.
Defects resulting from improper han-
dling are not subject to the guarantee.
Charging the battery
1. Connect the charging cable con-
nector (12) with the charging
socket (7) of the device.
2. Plug the charger (
13) into an
electrical outlet.
3.
The battery indicator (3) lights up:
red => Start of charging
red and yellow =>
Battery appr. half charged
red-yellow-green =>
Battery fully charged.
4. After the charging process,
disconnect the charger (
13)
from the mains supply.
Initial Operation
Switching ON and OFF
1. Press the on/off switch (8) to
start the device. The LED work
light (10) lights up during opera-
tion.
2. To turn it off, release the on/off
switch (8).
Overload protection: The safety cut-off of
the device switches off in case of overload.
Release the On/Off switch, the device can
be switched on again after a few seconds.
Checking the charge status
of the rechargeable battery
The battery indicator ( 3) signalises the
state of charge of the battery.
Press the On/Off switch, the state of
charge of the battery is displayed by
turning on the 3 coloured LED lights:
red-yellow-green =>
Battery fully charged
red and yellow =>
Battery appr. half charged
red =>
Battery is empty, please charge.
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Parkside IAN 273473 PSSA 3.6 C4 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Parkside IAN 273473 PSSA 3.6 C4 in the language / languages: English, German, Dutch, Danish, French as an attachment in your email.

The manual is 0,86 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info