568762
6
Zoom out
Zoom in
Previous page
1/24
Next page
5
G
UIDED SOUNDFIELD
S
URROUNDS/REARS (continued)
Fine Tuning the Guided Soundfield
Once you have decided on placement, connect the speaker following directions for Connection on page 6.
Before final tightening of the flange screws, rotate speaker until drive assembly points in the desired
direction. Then, follow directions for Installation on page 7. To readjust direction of sound, loosen screws,
rotate drive assembly until it points in the desired direction, then re-tighten screws.
Speaker Impedance with Multiple Speakers
If you are planning to use multiple speakers per amplifier channel first determine the number of speakers
your amplifier is capable of driving safely. Check your amplifier’s specifications to determine minimum safe
speaker impedance load (in ohms).
The MINIMUM load impedance of one
Paradigm
®
/Paradigm
®
Reference in-wall/
in-ceiling speaker is:
4 ohms per channel
The MINIMUM load impedance of one ‘SM’ model is:
8 ohms per channel when wired for Stereo Input
4 ohms per speaker when wired for Mono Input
Each additional speaker you connect will drop nominal impedance by half. We recommend using a Paradigm
®
VC-150 volume control when connecting more than two speakers. See your dealer for more information.
COLOR-MATCH PAINTING (optional)
Your new in-wall/in-ceiling speakers have either a textured or powder-coated finish in neutral white to
blend into any area. They may also be painted to match any decor. If you plan to paint your speakers, paint
them before installation (remove them from the wall before you start!).
Please note:
Do not paint the surface behind the grille
Do not heat-cure your newly painted speakers
Avoid painting the rear surface of the speaker protect it by masking it
To Paint, Follow These Steps:
1) Remove the metal grilles and position the paint mask (supplied) in its place.
2) Lightly sand speaker flanges (models with metal frames only) with fine sandpaper (included)
to provide better paint adhesion.
3) In a well-ventilated area, apply several light coats of paint, letting the speaker dry completely
between coats. Follow the paint manufacturer’s directions.
4) When painting grilles, be careful to not plug holes with paint. Remove protective cloth from inside
grille before painting, and re-attach after paint has dried. It is easier to spray grille than use a brush.
Do not
paint grilles when they are installed on the speaker.
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Paradigm SA-ADP at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Paradigm SA-ADP in the language / languages: English, French as an attachment in your email.

The manual is 0,78 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info