568788
8
Zoom out
Zoom in
Previous page
1/24
Next page
7
2
. Connecting and Installing (continued)
Installing
:
b) Holding the speaker’s front lip with your thumbs and index fingers, push the mounting screws toward
each other with your other fingers so that the brackets fit through the hole. Release the screws and
gently push the speaker to the wall/ceiling. (Fig. 5a)
While holding the speaker in place, alternately tighten each screw until the speaker is firmly installed.
(Fig. 5b)
Round
and Square Speakers
With grille removed and bracket attached to speaker, place complete assembly to the wall or ceiling and
Connecting
(except models with ‘SM’ in their name, see connection instructions farther below):
a) Connect speaker cable as outlined on page 6, Fig. 8a, in section on Rectangular Speakers.
Installing
:
b) For Speakers With Two Mounting Screws: Holding the speaker flange with your fingers, push on
the screw heads with your thumbs to extend rear bracket. The bracket is oblong, extending past
each screw. Fit one oblong end into the hole far enough to allow the other oblong end to also fit
into the hole. (Fig. 6a)
For Speakers With Four
Mounting Screws: Holding the speaker’s front lip with your thumbs and
index fingers, push the mounting screws toward each other with your other fingers, so the mounting
brackets can fit through the hole with an “up-and-in” motion. Release the screws and gently push the
speaker to the ceiling/wall. (Fig. 7a)
Models with Guided Soundfield
: Rotate the speaker so that the drive assembly points in desired
direction (not shown).
c) While holding the speaker in place, alternately tighten each screw until the speaker is firmly
installed. (Figs. 6b and 7b)
Connecting ‘SM’ Models
Stereo Input
(Single Speaker) (Fig.8b): Connect one speaker channel at a time to your receiver/amplifier.
Connect the Right red (+) amplifier terminal to the Right red (+) speaker terminal and the Right black (-)
amplifier terminal to the Right black (-) speaker terminal. Connect the Left red (+) amplifier terminal to
the Left red (+) speaker terminal and the Left black (-) amplifier terminal to the Left black (-)
speaker terminal.
Follow the installation instructions provided earlier.
Mono Input
(Fig. 8c): Connect one speaker at a time to the left and right channels of your
receiver/amplifier. First, convert the Right speaker to Mono: Using a short piece of cable, connect the
Right red (+) speaker terminal to the Left red (+) speaker terminal and the Right black (-) speaker terminal
to the Left black (-) amplifier terminal. Then
Connect the Right red (+) amplifier terminal to the Right red (+) speaker terminal and the Right black (-)
amplifier terminal to the Right black (-) speaker terminal.
Repeat entire procedure for Left speaker, then follow installation instructions provided earlier.
3. Installing the Grille
Press the grille into the groove on the front face of the speaker (not shown). Magnets hold the grille in
place (in-ceiling models only).
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Paradigm PV-50R at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Paradigm PV-50R in the language / languages: English, French as an attachment in your email.

The manual is 0,78 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info