628498
30
Zoom out
Zoom in
Previous page
1/56
Next page
Appendix
30 Operating Instructions
Troubleshooting
When experiencing problems, please refer to the table below for possible solutions. If the problem persists,
contact your dealer. In the case of the kinds of trouble which are not described in the table below, refer to
“Troubleshooting” in the software help.
Symptom Possible cause and solution See page
The LEDs do not light
when the power switch is
turned on.
Check that the power cord is properly plugged in.
If the problem persists, unplug the cord momentarily, wait about
2 seconds, and plug it in again.
The Error LED (red)
blinks twice repeatedly at
about 1-second intervals.
You turned on the power switch while touching the screen board.
Do not touch the screen board for about 3 seconds after turning
on the power switch. If the Error LED (red) continues to blink
even after you turn the power switch off and then on again,
contact your dealer.
Error LED (red) is
blinking.
Turn off the power, and turn it on.
If the problem persists, contact your dealer.
The computer does not
recognize the elite
Panaboard.
The elite Panaboard and your computer are not connected.
Securely connect the elite Panaboard and your computer
using a USB cable.
The USB cable is connected to a USB hub.
Do not connect the elite Panaboard through a USB hub.
The connection between
the computer and the
elite Panaboard is
unexpectedly lost.
Check that the elite Panaboard is in an operable state, and that the
USB cable is properly connected.
The elite Panaboard
response is delayed.
Other applications or anti-virus software are active.
Shut down the other applications and anti-virus software.
5
In Windows 7, there is a
considerable delay in the
elite Panaboard
response when you
touch the screen board
with your finger.
The USB operation is erratic.
Unplug and reconnect the USB cable.
The point of control is out
of alignment with your
finger or the electronic
pen.
The projected image is misaligned.
Perform the calibration again.
The display resolution (pixel count) has been changed.
Perform the calibration again.
The edge of the projected image is curved.
Perform Advanced Calibration.
26
26
25
Lines or comments
drawn with your finger
are not shown on the
computer screen.
You are touching the screen board with a part of your hand other
than your finger.
Use only your finger tip to touch the screen board.
You are touching too lightly with your finger.
Touch the screen board more firmly.
30


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Panasonic UB-T880 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Panasonic UB-T880 in the language / languages: English as an attachment in your email.

The manual is 11,48 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Panasonic UB-T880

Panasonic UB-T880 User Manual - German - 56 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info