511651
20
Zoom out
Zoom in
Previous page
1/24
Next page
20
1
Turn the 3D Eyewear on and put it on
Connection status and battery status are displayed on the bottom right of the screen.
2
View the 3D images
Safety precautions will be displayed when you first watch the 3D image. Select [Yes] or [No] to continue to view
3D images.
Note
Turn off the 3D Eyewear after using it.
Use the 3D Eyewear within approximately 3.2 m from the TV. You cannot view the 3D images with the 3D Eyewear
too far from the TV, because of the difficulty of receiving radio waves from the TV.
The range may be shortened depending on the obstacles between the TV and the 3D Eyewear, or the surrounding
environment.
Use the 3D Eyewear where there is no interference from other Bluetooth devices.
3D content will not be correctly visible if the 3D Eyewear is worn upside down or back-to-front.
When viewing 3D images, make sure your eyes are at an approximately horizontal level and keep a position where
you do not see double images.
If light appears to flicker under fluorescents or dimmers when using the 3D Eyewear, change the setting of [3D
Refresh Rate] in [3D Settings] (Picture Menu).
There are differences in the viewing range of the 3D Eyewear among individuals.
FAQs
Before requesting service or assistance, please follow these simple guides to solve the problem.
For more information, refer to [eHELP] (Support > FAQs).
The TV does not switch on
Check the mains lead is plugged into the TV and the socket outlet.
The fuse in the mains plug may have blown. Replace it with one of an identical rating. (p. 3)
The TV goes into Standby mode
Auto power standby function is activated.
The remote control does not work or is intermittent
Are the batteries installed correctly? (p. 13)
Has the TV been switched on?
The batteries may be running low. Replace them with new ones.
Point the remote control directly at the TV’s remote control signal receiver (within about 7 m and a 30 degree
angle of the signal receiver).
Situate the TV away from sunshine or other sources of bright light not to shine on the TV’s remote control signal
receiver.
Electronic Touch Pen does not work
Check that the batteries are fresh, are of the same type and are installed with the correct polarity (+ & -).
Check if the pairing range is within 50 cm.
The Electronic Touch Pen automatically turns off if pairing cannot be performed within 2 minutes. In this case, pair
again.
The Electronic Touch Pen automatically turns off if unused for 5 minutes.
(When the Electronic Touch Pen is turned on, the indicator lamp blinks but turns off in several minutes.) Turn the
power on again.
No image can be displayed
Check the TV is turned on.
Check the mains lead is plugged into the TV and the socket outlet.
Check the correct input mode is selected.
Check the setting of [AV2] ([COMPONENT] / [VIDEO]) in [Input Selection] to match the output of the external
equipment.
Is [Contrast], [Brightness] or [Colour] in the Picture Menu set to the minimum?
Check all required cables and connections are firmly in place.
Unusual image is displayed
Turn the TV off with Mains power On / Off switch, then turn it on again.
If the problem persists, initialise all settings. [Shipping Condition] in [System Menu] (Setup Menu)
20


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Panasonic TX-P50GT60 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Panasonic TX-P50GT60 in the language / languages: English, French as an attachment in your email.

The manual is 1,03 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Panasonic TX-P50GT60

Panasonic TX-P50GT60 User Manual - English - 72 pages

Panasonic TX-P50GT60 User Manual - German - 240 pages

Panasonic TX-P50GT60 User Manual - Dutch - 72 pages

Panasonic TX-P50GT60 User Manual - Dutch - 239 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info