613072
23
Zoom out
Zoom in
Previous page
1/32
Next page
23
RQT9756
The following messages or service numbers may
appear on the unit’s display.
“--:--”
You plugged the AC mains lead in for the first time or there was a
power failure recently. Set the time (l 18).
“ADJUST CLOCK”
Clock is not set. Adjust the clock accordingly.
“ADJUST TIMER”
Play timer is not set. Adjust the play timer accordingly.
“AUTO OFF”
The unit has been left unused for about 30 minutes and will shut
down within a minute. Press any button to cancel it.
“CANNOT SET”
Select an audio source other than “AIRPLAY” or “BLUETOOTH”.
“CHECKING CONNECTION”
The unit is checking the connected iPod/iPhone/iPad.
If this display keeps appearing, make sure that the battery of the
iPod/iPhone/iPad is not depleted and that the iPod/iPhone/iPad is
turned on and connected correctly (l 6).
“DL ERROR”
The software download has failed. Press any button to exit.
Please try again later.
The server cannot be found. Press any button to exit. Make sure
that the wireless network is connected to the Internet.
“ERROR”
Incorrect operation is performed. Read the instructions and try
again.
“F” (“ stands for a number.)
There is a problem with this unit.
Note down the displayed number, disconnect the AC mains lead
and consult your dealer.
“FAIL”
Updating or setting has failed. Read the instructions and try again.
“ILLEGAL OPEN”
Sliding door is not in correct position. Turn the unit off and on
again. If this display appears again, consult the dealer.
“IPOD_DOCK OVER CURRENT ERROR”
“IPOD_PORT OVER CURRENT ERROR”
The iPod/iPhone/iPad is drawing too much power. Disconnect the
iPod/iPhone/iPad and turn the unit off and on again.
The USB device is drawing too much power. Switch to “CD”
mode, remove the USB and turn the unit off.
“LEVEL 0”
There is no link between this unit and the wireless network router.
Try the following operations:
Check that the wireless network router is turned on.
Turn this unit off and on again.
Reset the wireless network settings. (l 7)
If the problem persists, consult your dealer.
“LEVEL j
When “D.CONNECT” is set to “ON” the Wi-Fi signal strength
cannot be checked. To check the Wi-Fi signal strength from the
wireless network router, set “D.CONNECT” to “OFF”. (l 11 )
“LINKING”
This unit is communicating with the wireless network router to
complete the network settings.
Depending on the wireless network router this process may take a
few minutes. Try moving this unit closer to the wireless network
router.
“NOCONNECT”
This unit is not connected to the network.
Check the network connection. (l 7)
“NODEVICE”
The iPod/iPhone/iPad device is not inserted correctly. Read the
instructions and try again (l 6).
The battery of the iPod/iPhone/iPad is depleted. Charge the iPod/
iPhone/iPad and turn it on before connecting.
The USB device is not inserted. Check the connection.
“NO DISC”
Insert the disc to be played (l 6).
[SC-HC58DB]
“NO MEMORY”
There are no preset DAB/DAB+ stations to select. Preset some
channels. (l 15)
“NO PLAY”
A CD that is not in CD-DA or MP3 format is inserted. It cannot be
played.
If there are more than 255 albums or folders (audio and
non-audio), some of the MP3 files in these albums may not be
read and played. Transfer these music albums to another USB.
Alternatively, reformat the USB device and save these music
albums prior to saving the other non-audio folders.
[SC-HC58DB]
“NO SIGNAL”
This station cannot be received. Check your antenna (l 5).
“NOT SUPPORTED”
You have connected an iPod/iPhone/iPad that cannot be played
(l 24).
If the iPod/iPhone/iPad is compatible, turn it on and connect it
correctly.
The connected iPod touch/iPhone/iPad is not connected to a
wireless network. Connect it to a wireless network and try again.
(l 7)
“READING”
The unit is checking the CD information. After this display has
disappeared, start operating.
“REMOTE ” (“ stands for a number.)
The remote control and this unit are using different codes. Change
the code on the remote control.
When “REMOTE 1” is displayed, press and hold [OK] and [ ]
for more than 4 seconds.
When “REMOTE 2” is displayed, press and hold [OK] and [CD/
RADIO] for more than 4 seconds.
“SET WI-FI”
The connected iPod touch/iPhone/iPad is not connected to a
wireless network. Connect it to a wireless network and try again.
(l 7)
[SC-HC58DB]
“SCAN FAILED”
Stations are not receivable. Check your antenna and try Auto
scanning (l 14).
If “SCAN FAILED” is still displayed find the best signal reception
with the “MANUAL SCAN” tuning function. (l 15)
Messages
SC-HC58DBEB_DBGN_GS~RQT9756-B.book 23 ページ 2013年5月28日 火曜日 午後4時56
23


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Panasonic SCHC58DBGN at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Panasonic SCHC58DBGN in the language / languages: English as an attachment in your email.

The manual is 4,69 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Panasonic SCHC58DBGN

Panasonic SCHC58DBGN User Manual - English - 1 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info