612839
14
Zoom out
Zoom in
Previous page
1/24
Next page
14
RQT9743
[SC-HC38DB]
DAB/DAB+ reception is poor.
Keep the antenna away from computers, televisions, other cables
and cords.
Use an outdoor antenna (l 5).
A beat sound or noise is heard while receiving
radio broadcast.
Adjust the position of the antenna.
Try to keep a certain amount of distance between the antenna and
AC mains lead.
Try using an outdoor antenna if there are buildings or mountains
nearby.
Switch the television or other audio players off or separate it from
this unit.
Keep this unit away from mobile phones if the interference is
apparent.
[SC-HC38] ([Australia[and[New[Zealand[ only)
Stations cannot be selected.
Change the AM frequency step.
1 Press [RADIO] to select “AM”.
2 Press and hold [SELECTOR] on the unit.
After a few seconds the display changes to show the current lowest
frequency. Continue to hold the button down. The lowest frequency
changes and the step is changed.
[SC-HC38] ([Australia[and[New[Zealand[ only)
A low hum or noise is heard during AM broadcast.
Keep the AM antenna away from this unit, other cables and cords.
Cannot charge or operate.
Have you selected the appropriate selector?
Press [iPod] to select either “IPOD_DOCK” or “IPOD_PORT”.
Check that the iPod/iPhone/iPad is connected properly. (l 6)
The battery of the iPod/iPhone/iPad is depleted. Charge the iPod/
iPhone/iPad, and then operate again.
Connect the iPod/iPhone/iPad again or try to restart the iPod/
iPhone/iPad.
When this unit is in standby mode, charging will not start when
using the “IPOD_PORT” connection.
Turn this unit on and make sure the charging has started before
switching this unit to standby mode.
Pairing cannot be done.
Check the Bluetooth
®
device condition.
The device cannot be connected.
The pairing of the device was unsuccessful or the registration has
been replaced. Try pairing the device again. (l 7)
This unit might be connected to a different device. Disconnect the
other device and try pairing the device again. (l 7)
The device is connected but audio cannot be heard
through this unit.
For some built-in Bluetooth
®
devices, you have to set the audio
output to “SC-HC38” manually. Read the operating instructions for
the device for details.
The sound is interrupted.
The device is out of the 10 m communication range. Bring the
Bluetooth
®
device closer to this unit.
Remove any obstacle between this unit and the device.
Other devices that use the 2.4 GHz frequency band (wireless
router, microwaves, cordless phones, etc.) are interfering. Bring
the Bluetooth
®
device closer to this unit and distance it from the
other devices.
Select “MODE 1” for stable communication. (l 7)
The remote control doesn’t work properly.
The remote control and this unit are using a different code.
(l 15, “REMOTE ”)
Is the battery depleted or is the battery inserted incorrectly? (l 4)
The following messages or service numbers may
appear on the unit’s display.
“--:--”
You plugged the AC mains lead in for the first time or there was a
power failure recently. Set the time (l 12).
“ADJUST CLOCK”
Clock is not set. Adjust the clock accordingly.
“ADJUST TIMER”
Play timer is not set. Adjust the play timer accordingly.
“AUTO OFF”
The unit has been left unused for about 30 minutes and will shut
down within a minute. Press any button to cancel it.
“CANNOT SET”
Select an audio source other than “BLUETOOTH”.
“CHECKING CONNECTION”
The unit is checking the connected iPod/iPhone/iPad.
If this display keeps appearing, make sure that the battery of the
iPod/iPhone/iPad is not depleted and that the iPod/iPhone/iPad is
turned on and connected correctly (l 6).
“ERROR”
Incorrect operation is performed. Read the instructions and try
again.
“F” (“ ” stands for a number.)
There is a problem with this unit.
Note down the displayed number, disconnect the AC mains lead
and consult your dealer.
Radio
Confirm the antenna(s) are properly connected. (l 5)
iPod/iPhone/iPad operations
Bluetooth
®
Remote control
Messages
SC-HC38_DBEB_DBGN_GS~RQT9743-B.book 14 ページ 2013年5月28日 火曜日 午後5時1
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Panasonic SCHC38EB at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Panasonic SCHC38EB in the language / languages: English as an attachment in your email.

The manual is 3,58 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info