612795
56
Zoom out
Zoom in
Previous page
1/64
Next page
References
RQT6345
56
The picture on the TV disappears
or stripes appear on the screen.
The location and orientation of the antenna are incorrect. If you are using an indoor antenna,
change to an outdoor antenna.
The TV antenna wire is too close to the unit. Separate the antenna wire of the TV set from the unit.
Noise is heard.
The stereo indicator flickers or
doesnt light.
Sound is distorted.
A beat sound is heard.
A low hum is heard during AM
broadcasts.
Use an outdoor antenna. 7
Turn the TV off or separate it from the unit.
Separate the antenna from other cables and cords.
No sound.
Sound stops.
Sound is unfixed, reversed or
comes from one speaker only.
Humming heard during play.
ERROR is displayed.
“–:–– appears on the display.
F61 is displayed.
The display starts up even after
the unit is turned off.
DTS NO AUDIO is displayed.
DTS CD is displayed.
DVD U11 is displayed.
DVD HMM is displayed.
(MM will be numbers.)
Turn the volume up.
The speaker cables may be shorted. Turn the unit off, check and correct the connections and turn
the unit on. 8
Switch off the unit, determine and correct the cause of the problem, then switch the unit on. Causes
include shorting of the positive and negative speaker wires, straining of the speakers through
excessive volume or power, and using the unit in a hot environment. 8
Check the speaker connections. 8
An AC power supply cord or fluorescent light is near the cables. Keep other appliances and cords
away from this units cables.
If possible in your area, turn the AC power supply cords plug or connector over to reverse the
plugs polarity.
Incorrect operation performed. Read the instructions and try again.
You plugged the power supply cord in for the first time or there was a power failure recently.
Set the time. #
Check and correct the speaker cords connection.
If this does not fix the problem, there is a power supply problem. Consult the dealer.
The demonstration feature (DEMO) is on. Turn it off if it is not required. #
This unit is unable to decode DTS signals.
This unit is unable to decode DTS signals.
This disc is dirty. Wipe it with a soft cloth.
A problem has occurred. Turn the unit off and unplug the AC power supply cord. Wait a moment
and then plug the cord in and turn on the unit again. If the unit is still not working correctly, consult
your dealer.
Troubleshooting guide
Before requesting service, make the below checks. If you are in doubt about some of the check points, or if the remedies indicated in the
chart do not solve the problem:
In the U.S.A., contact the Panasonic Customer Call Center at 1-800-211-7262, or e-mail consumerproducts@panasonic.com, or web
site (http://www.panasonic.com).
In Canada, contact Panasonic Canada Inc. Customer Care Centre at 1-800-561-5505, web site (www.panasonic.ca), or an authorized
Servicentre closest to you.
Reference pages are shown as black circled numbers 8.
Common Problems
Using the cassette deck
Listening to the radio
When there is a television set nearby
Poor quality sound.
Recording is not possible.
Clean the heads. )
If the erasure prevention tabs have been removed, cover the holes with adhesive tape. |
56


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Panasonic SCDK20P at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Panasonic SCDK20P in the language / languages: English as an attachment in your email.

The manual is 2,46 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info