Ensure the stand is fastened on straight by lightly tightening the top and
bottom screws alternately until fully tightened.
∑ Front speaker units ∑ Pipes ∑ Bases ∑ Large screws
(XSS6+14FZ)
∑ Small screws
(XSN5+10FN)
Supplied Accessories
Make sure you have all
the indicated components
before assembly, setup,
and connection.
Front speaker
2
Attach the stand to the front speaker.
≥There is no difference between the right and left speakers and stands.
≥Using the polyfoam included with this unit may be convenient.
Preparation
≥ To prevent damage or scratches, lay a soft cloth and perform assembly on it.
≥ For assembly, use a Phillips-head screwdriver.
1
Attach the pipe to the base.
1,138 mm
Stopper
screw
Do not remove.
Speaker
Pipe
Base
Attached to lower
rear of speaker
Connection terminals
You can also attach to the upper rear of the speaker.
The height of the speaker is indicated in the diagram on the right when
attaching the stand to the upper rear or lower rear of the speaker.
Small screws
∫ Front speaker height
(Assembled diagram)
Mounting
plate
Thread the speaker
cable through here.
Groove
Lessen excess speaker cable.
2 Insert the pipe.
Insert the pipe while slightly
pulling on the speaker cable.
Large screws
968 mm
796 mm 625 mm
Attached to upper
rear of speaker
Cable
Rear side of base
The supplied stands are specially designed for
attachment to Panasonic SB-PF1000 front speakers.
Only use as indicated in this setup.
You can adjust within this range.
For your reference
You can enjoy good acoustics by adjusting the
height of the speaker with the height of the
television so the center position of both are
approximately the same.
(Speaker height adjustment ➜ procedure 3)
Cable
Holes for screws
Polyfoam
1 Thread the speaker cable through the base.
3 Secure the pipe to the base.
Ensure the screws are securely fastened by lightly tightening the left
and right side screws alternately until fully tightened. (The heads of the
screws protrude slightly even if you have fully tightened them.)
678 mm
