Buttons such as Ê function the same as the controls on the remote control.
>
=
Troubleshooting guide
Before requesting service, make the below checks. If you are in doubt about some of the check points, or if the remedies indicated in the chart do not solve the problem,
consult your dealer for instructions.
No play.
•The disc isn’t correctly set.
•The disc is scratched or dirty. (Tracks skipped.)
•There is moisture on the lens. Wait about an hour
and then try again.
MP3 cannot be read.
•
You may not be able to play MP3 if you have copied a
multi-session disc that has no data between sessions.
•When creating a multi session disc, it is necessary
to close the session.
•The amount of data on the disc is too small. Set the
amount of data to greater than approximately 5 MB.
Sound is unfixed,
reversed or comes
from one speaker only.
•Check the speaker connections. (→ page 3)
No sound or there is
a lot of noise.
•
Noise may occur when playing MP3 if recording quality is poor.
•Keep this unit away from mobile telephones.
•Turn the volume up.
•Switch off the unit, determine and correct the cause, then switch
the unit on. Causes include shorting of the positive and negative
speaker wires, straining of the speakers through excessive
volume or power, and using the unit in a hot environment.
Humming heard
during play.
•An AC mains lead or fluorescent light is near the cables.
Keep other appliances and cords away from this unit’s cables.
A beat sound is
heard while receiving
a radio broadcast.
•Turn the TV off or separate it from the unit.
A low hum or noise
is heard during AM
broadcasts.
•Keep the antenna away from other cables and
cords.
•Keep the AM antenna away from the unit.
The picture on the
television near the set
disappears or stripes
appear on the screen.
•The location and orientation of the antenna are
incorrect.
•
The TV antenna wire is too close to the unit. Separate
the antenna wire of the TV set from the unit.
DAB reception is
poor.
•Keep the antenna away from computers, televisions,
other cables and cords.
•Use an outdoor antenna
(
→
page 10).
Remote control
doesn’t work.
•
Check that the battery is inserted correctly. (
→
page 3)
•Replace the battery if it is worn.
No response even
when button is
pressed.
I want to erase the
memory and reset it.
•Use the following method to initialize the settings.
1.Remove the AC adaptor.
2.While pressing [
^
/I ] on the unit, insert the AC adaptor.
3.While continuing to press and hold [ ^/I ] ,
“----------------” appears.
– –:– –
•
You plugged the AC adaptor in for the first time or there
was a power failure recently. Set the time. (
→
page 8, 9)
– – –:– –
•The total programmed play time is more than 200 minutes.
Tracks can still be programmed and played.
PROGRAM FULL
•The number of programmed tracks is limited to 24.
No further tracks can be programmed.
NOT MP3 DISC
•A non-CD-DA or non-MP3 CD-ROM disc is inserted. Cannot be played.
ERROR
•Incorrect operation performed. Read the instructions and try again.
NO SERVICE•The station is currently not broadcasting.
NO SIGNAL
•This station cannot be received. Check your antenna (
→
page 3).
DATA
•Data broadcast being received over the DAB
broadcast signal. Cannot be used on this unit.
SCRAMBLE
•The broadcast station being received cannot be
accessed (E.g. pay per use etc.).
Scan Failed.
•Stations are not receivable. Check your antenna
and try Auto scanning
(
→
page 3, 7).
F □□
（
□□
stands for a number.)
• Turn the unit off, disconnect the AC adaptor, and
consult your dealer.
STATION FULL
•DAB station memory is full. Use the following
method to clear station memory.
1. Press [MENU].
2. Press [–] or [+] to select “STATION CLEAR”.
3. Press [ENTER]. “OK? Push ENTER” is displayed.
4. Press [ENTER].
Station memory is erased and the unit automatically
I am finding that my device is not reading the disc now and then and when it plays it seems to jump from on trac to another and eventually won’t play my CD
Submitted on 10-12-2022 at 19:26
Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.
Product:
Forumrules
To achieve meaningful questions, we apply the following rules:
First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.
Register
Register getting emails for Panasonic SC-EN9 at:
new questions and answers
new manuals
You will receive an email to register for one or both of the options.
Get your user manual by e-mail
Enter your email address to receive the manual of Panasonic SC-EN9 in the language / languages: English as an attachment in your email.
The manual is 1,77 mb in size.
You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.
The manual is sent by email. Check your email
If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.
The email address you have provided is not correct.
Please check the email address and correct it.
Your question is posted on this page
Would you like to receive an email when new answers and questions are posted? Please enter your email address.
