612616
6
Zoom out
Zoom in
Previous page
1/6
Next page
Matsushita Electric Industrial Co., Ltd.
Web Site : http://www.panasonic.co.jp/global/
RQT6901-B
M1202TK0
En
Notes
Speaker impedance and allowed input
SB-FS702 / SB-PC702 Impedance 6
Input power 100 W (DIN)
SB-FS802 / SB-PC802
Impedance 6
Input power 40 W (DIN)
The only receivers or amplifiers you should connect to these speak-
ers are those whose rated output does not exceed the above figures.
Using a receiver or amplifier with higher ratings than listed above can
cause abnormal sounds to occur because of excessive input, dam-
age to the receiver or speakers, and fire. If equipment is damaged in
any way or unexpected trouble occurs during playback, unplug the
system from its outlet and call a serviceman for help.
Protection circuitry
SB-FS702 / SB-PC702 / SB-FS802 / SB-PC802
These units incorporate protection circuitry to protect them from dam-
age caused by excessive input or abnormal signals; when excess
input is detected, input is automatically interrupted.
If sound is interrupted...
1.Reduce the volume of the receiver (or amplifier).
2.Check the sound source and connections for any problems.
If there is no problem, the protection circuitry will reset in a few
minutes.
After the protection circuit is reset...
Take care not to increase the receivers volume too high.
Excessive input
You can damage your speakers and shorten their useful
life if you play sound at high levels over extended periods.
Reduce the volume in the following cases to avoid damage :
When playing distorted sound.
When the speakers are receiving howling from a microphone or
record player, noise from FM broadcasts, or continuous signals from
an oscillator, test disc, or electronic instrument.
When adjusting the sound quality.
When turning the amplifier on or off.
Other notes
If irregular coloring occurs on your television :
These speakers are designed to be used close to a television, but the
picture may be affected with some televisions and set-up combina-
tions.
If this occurs, turn the television off for about 30 minutes.
The televisions demagnetizing function should correct the problem.
If it persists, move the speakers further away from the television.
You cannot remove the speaker net.
Keep magnetized items away.
Magnetized cards, bank cards, commuter passes, etc., can be dam-
aged if allowed too near speaker magnets. Clocks may also be af-
fected.
Avoid locations such as described below :
In direct sunlight
Near heating appliances or other sources of heat
Where the humidity is high
Maintenance
Clean these units with a soft, clean, dry cloth.
Clean regularly to maintain the polished surface.
Never use alcohol, paint thinner, or benzine to clean these units.
Before using chemically treated cloth, read the instructions that came
with the cloth carefully.
Specifications
SB-FS702 / SB-PC702
Type 2 way 2 speaker system Bass-reflex type
Speaker (s) Woofer: 6.5 cm cone type x 1
Fullrange: 6.5 cm cone type x 1
Impedance 6
Input power 200 W (Music), 100 W (DIN)
Sound pressure level 82 dB/W (1.0 m)
Crossover frequency 7 kHz
Frequency range 100 Hz 25 kHz (at 16 dB)
125 Hz 22 kHz (at 10 dB)
Dimensions (W x H x D)
SB-FS702 135 x 295 x 145 mm (with the stand)
SB-PC702 250 x 140 x 145 mm (with the stand)
Mass 1.55 kg
SB-FS802 / SB-PC802
Type 1 way 1 speaker system Bass-reflex type
Speaker (s) Fullrange: 6.5 cm cone type x 1
Impedance 6
Input power 80 W (Music), 40 W (DIN)
Sound pressure level 79 dB/W (1.0 m)
Frequency range 110 Hz 25 kHz (at 16 dB)
130 Hz 22 kHz (at 10 dB)
Dimensions (W x H x D)
SB-FS802 110 x 226 x 132 mm (with the stand)
SB-PC802 180 x 139 x 132 mm (with the stand)
Mass 0.93 kg
SB-WA55 / SB-WA54
SPEAKER SECTION
Type 1 way 1 speaker system Bass-reflex type
Speaker (s) Woofer: 17 cm cone type x 1
Impedance 6
Input power 200 W (Music), 100 W (DIN)
Sound pressure level 80 dB/W (1.0 m)
Frequency range (with amp) 32 300 Hz (at 16 dB)
38 240 Hz (at 10 dB)
AMPLIFIER SECTION
Output power 100 W (6 ) (THD 0.9%)
Input sensitivity / Input Impedance 300 mV/33 k (RCA jack)
Phase switching
SB-WA55 NORMAL/REVERSE
Low pass filter SB-WA55 50 200 Hz Variable
SB-WA54 200 Hz Fixed
GENERAL
Power supply
For the United Kingdom, Australia and New Zealand
AC 230 240 V, 50 Hz
For others AC 220 240 V, 50/60 Hz
Power consumption 168 W
Dimensions (W x H x D)
SB-WA54 / SB-WA55 For Australia and New Zealand
162 x 457 x 420 mm
SB-WA55 For others 162 x 457 x 434 mm
Mass SB-WA55 10.8 kg
SB-WA54 10.6 kg
Specifications are subject to change without notice.
Mass and dimensions are approximate.
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Panasonic SBTP20EB at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Panasonic SBTP20EB in the language / languages: English as an attachment in your email.

The manual is 0,27 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info