612612
4
Zoom out
Zoom in
Previous page
1/6
Next page
RQT6260
4
Speaker set-up
The illustration shows examples of connection.
Front speaker (Left)
Center speaker
Receiver or amplifier (not included)
Front speaker (Right)
Surround speaker (Right)
Surround speaker (Left)
Speaker cables (not included)
Location
The front, center, and surround speakers should be placed at ap-
proximately the same distance from the listening position. The angles
in the diagram are approximate.
Positioning for best effect
How you set up your speakers can affect the bass and the sound
field. Note the following points.
Place speakers on flat, secure bases.
Placing speakers too close to floors, walls, and corners can result
in excessive bass.
Cover walls and windows with thick curtain.
Place the surround speakers on the side of or slightly behind the
seating position, about one meter higher than ear level.
Vibration may cause distortion in the picture if the center speaker
is placed directly on the television. Place it on a rack or shelf.
Place the speakers at least 5 cm (2w) from the wall as they have
bass reflex ports in the rear.
Do not attempt to attach these speakers to walls using methods
other than those described in this manual.
Connections
Confirm the colors of the cords to ensure correct connection. Incor-
rect connection can damage the unit.
Before making the connections, switch OFF the power to the amplifier.
Use with an amplifier having 6 impedance for these speakers.
Be sure to connect only positive (+) wires to positive (+) terminals,
and negative () wires to negative () terminals.
Connecting the cables
Before connection
Strip the outer covering from the end of the cable to a length of
approximately 15 mm (19/32w) and twist the center wire.
If using a commercially-available 4-mm plug cable
Fully tighten the speaker terminal knob, and then insert the end of
the plug cable into the top of the knob.
To prevent damage to circuitry, never short-circuit positive (+) and
negative () speaker wires.
Emplacement des enceintes
Lillustration ci-dessus démontre des exemples de raccordement.
Enceinte avant gauche
Enceinte centrale
Récepteur ou amplificateur (vendus séparément)
Enceinte avant droite
Enceinte ambiophonique droite
Enceinte ambiophonique gauche
Câbles de raccordement (vendus séparément)
Emplacement
Positionner les enceintes à une distance égale de la position
d’écoute. Les angles illustrés sont approximatifs.
Positionnement pour le meilleur rendement
Lemplacement des enceintes peut affecter les graves et le champ
sonore. Lire attentivement les points suivants.
Placer les enceintes sur une surface droite, de niveau et sécuritaire.
Afin d’éviter une production excessive des graves, ne pas placer
les enceintes trop près du plancher, des murs ou des coins.
Recouvrir les murs et les fenêtres dun rideau épais.
Les enceintes ambiophoniques doivent être placées à environ un
mètre plus haut que le niveau des oreilles, de chaque côté ou
légèrement en arrière de la position d’écoute.
La vibration peut affecter la qualité de limage si lenceinte centrale
est placée directement sur le téléviseur. Placer-la sur un support
ou une étagère.
Munies dun accès à évent réflex à larrière, les enceintes doivent
êtres placées au moins à 5 cm (2 po) du mur.
Ne pas fixer ces enceintes au mur en utilisant une méthode
dinstallation autre que celle donnée dans ce manuel.
Raccordements
Confirmer la couleur des câbles afin dassurer un bon raccordement.
Un mauvais raccordement pourrait endommager les enceintes.
Avant de faire les raccordements, couper le contact sur le récepteur
ou lamplificateur.
Utiliser un amplificateur ayant une impédance de 6 ohms.
Sassurer de raccorder les fils positifs (+) aux bornes positives (+)
et les fils négatifs () aux bornes négatives ().
Raccordement des câbles aux enceintes
Avant raccordement
Dénuder lextrémité du câble sur une longueur denviron 15 mm
(19/32 po), puis en torsader l’âme.
Avec un câble doté dune fiche de 4 mm
Serrer la molette de la borne puis introduire lextrémité de la fiche
dans le haut de la molette.
Afin de prévenir tout dommage aux circuits, ne jamais court-circuiter
les fils positif (+) et négatif ().
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Panasonic SBPF500 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Panasonic SBPF500 in the language / languages: English, French as an attachment in your email.

The manual is 0,46 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info