19
RQT6840
Others
The radio
Preset the stations one at a time.
1.Tune to the station.
2.Press [MEMORY].
3.Press [TUNE 2 or 1] to select a channel.
4.Press [MEMORY].
For your reference
FM stations can also be preset in the MONO mode.
1.Tune to “FM 87.9 MHz”.
2.Press and hold [MEMORY].
The FM stations the unit can receive are preset in channels 1 to 30.
3.Tune to “AM 530 kHz”.
4.Press and hold [MEMORY].
The AM stations the unit can receive are preset in channels 21 to 30.
(FM stations are replaced if any were preset in these channels.)
During automatic presetting, the memory indicator (˜) flashes and the
frequency scrolls. The memory indicator and channel numbers are
displayed for a second when a station is preset.
The last station to be preset is displayed when presetting finishes.
For your reference
Even if the power supply cord is disconnected from the household AC
outlet, the stations remain in memory for approximately two weeks.
1.Press [PRESET].
The channel number flashes for about 5 seconds.
2.Press [TUNE 2 or 1].
Hold down the buttons to change channels faster.
On the remote control
Press [1 , CH, 2].
or
Press the numbered buttons.
For channels 1 to 9, press the corresponding number.
For channels 10 or over, press [
>
=
10, ENTER], then the two digits.
e.g. To select channel 21: [
>
=
10, ENTER] / [2] / [1]
Automatic presetting
Manual presetting
Selecting channels
Manual tuning
Direct tuning (on the remote control)
You can tune radio stations manually by selecting the station’s
frequency.
1.Press [INPUT SELECTOR] to select “TUNER”.
2.Press [BAND] to select “FM” or “AM”.
3.Press [TUNE 2 or 1] to select the frequency.
Tuning intervals: FM – 0.2 MHz
AM – 10 kHz
Improving reception
¡ FM mode
You can improve FM reception by switching reception to monaural.
Press [FM MODE].
“MONO” lights.
Press [FM MODE] again to cancel.
¡ For your reference
DVD players can interfere with radio reception. Turn the DVD player off
or move it further away from the antennas if this occurs.
1.Press [TUNER/BAND RECEIVER]. ( )
Press [TUNER/BAND]. ( )
The band changes each time you press the button.
2.Press [DISC, DIRECT TUNING].
3.Press the numbered buttons to enter the
frequency.
e.g. To select 107.9 MHz, press [1] / [0] / [7] / [9]
Tuning intervals: FM – 0.1 MHz
AM – 10 kHz
¡ If you do not press a button while the cursor is flashing, the display
returns to the frequency being received.
¡ If the frequency has not been input correctly, “ERROR” will be
displayed.
SA-XR25
SA-XR45
