502462
23
Zoom out
Zoom in
Previous page
1/48
Next page
23
RQT8743
Auto speaker setup using the setup microphone
ENGLISH
When one of the following error messages appears, press [TEST, –AUTO] to cancel and perform the auto speaker setup again.
You can also perform automatic speaker detection only (
á
page 10).
Speaker placement, speaker directions and other conditions
may prevent correct setting.
The unit sets the lowpass filter frequency at the value of the
speaker capable of reproducing the lowest frequency signal
among speakers judged as “SMALL”.
When left and right speakers differ in size, they are set as “SMALL”.
• When surround speakers and surround back speakers differ in
size, they are set as “SMALL”.
• Left and right front speakers are set as “LARGE
” even if their
size is “SMALL” when you perform the auto speaker setup
without connecting the subwoofer.
The connection status is set and the level is adjusted for the subwoofer.
The unit does not detect or correct polarity of left and right
front speakers when you select “YES ” in “Making bi-wire
setting” (á page 20).
HDAVI Control (á page 13) does not work during the auto
speaker setup.
The auto speaker setup is unavailable while muting (
á
page 29) is on.
The unit sets at 15 meters the distance of speakers located
more than 15 meters away from the seating area. The set
distance is displayed as “OVER ” (á page 33).
Speakers whose polarity was automatically adjusted are
displayed with “ ” such as “L 3.0 – ” (á page 33).
Speaker settings made with the setup microphone are cancelled
when you perform automatic speaker detection (
á
page 10).
When the “AUTO SPEAKER SETUP” indicator is off
after the auto speaker setup:
Auto speaker settings have been cancelled as a result of
various setting changes.
Speaker size
LARGE: Speakers that can sufficiently reproduce the bass
range down to 20 Hz.
SMALL: Speakers that do not satisfy the requirements for
LARGE speakers.
You can perform steps instructed in “Setting speakers and their
sizes” (á page 33) to change speaker sizes set automatically.
Lowpass filter
When the speaker size is “SMALL”, the unit cannot sufficiently
reproduce the bass range.
You can set the lowpass filter frequency according to the
playback frequency range and arrange the unit to output the
missing bass range from the subwoofer.
With the setup microphone, the unit automatically sets the following.
STEP1
STEP2
STEP3
DISTANCE : The unit measures the distance between each speaker and the seating area and corrects the sound delay
in the seating area. The maximum speaker distance for correcting the delay is 15 meters.
POLARITY : The unit checks the polarity of each speaker and, when the polarity is wrong, corrects it.
Select “CHECK NO ” in “Setting the unit against automatic polarity adjustment” (á page 34) before starting the auto
speaker setup when you do not want the unit to adjust polarity automatically.
SIZE / FREQUENCY : The unit measures acoustic characteristics of the room including speaker characteristics (size
and lowpass filter settings) and adjusts them.
LEVEL : The unit checks the output level of each speaker and makes adjustment.
Error messages
Message Cause Countermeasure
• The setup microphone is not connected. • Connect the setup microphone properly.
The setup microphone does not catch test signals.
• Check if the microphone is placed properly.
• Loud noise is preventing measurement.
Perform the auto speaker setup again when the
room is quiet.
Turn off an air-conditioner and other equipment
that are producing noise.
• A speaker is too far.
• An error occurred from an unknown cause.
• Check speaker locations.
• Perform the setup again.
The right surround back speaker was detected,
but the left surround back speaker was not
detected.
Connect to the left surround back speaker terminal
when you connect only one surround back speaker.
Check the left surround back speaker’s connections.
Surround back speakers were detected, but left
and right surround speakers were not detected.
Connect surround speakers as well when you
connect surround back speakers.
Unable to detect one or both of the two surround
speakers
• Check connections.
Unable to detect one or both of the two front
speakers
• Check connections.
Test signals from the speakers are too weak to
allow accurate measurement with the
microphone.
Change the microphone location (height, direction etc.).
• Check if there is any obstacle near a speaker that
is blocking the test signals.
Set the subwoofer volume to the normal listening level.
Note
SA_XR700_EG_GN_ (RQT8743_B)ver.3.fm 23 ページ 2006年8月31日 木曜日 午前9時7分
23


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Panasonic SA-XR700 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Panasonic SA-XR700 in the language / languages: English as an attachment in your email.

The manual is 3,5 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Panasonic SA-XR700

Panasonic SA-XR700 User Manual - English - 48 pages

Panasonic SA-XR700 User Manual - English - 52 pages

Panasonic SA-XR700 User Manual - English - 52 pages

Panasonic SA-XR700 User Manual - German - 144 pages

Panasonic SA-XR700 User Manual - Dutch, Danish - 144 pages

Panasonic SA-XR700 User Manual - French, Italian - 144 pages

Panasonic SA-XR700 User Manual - Polish - 144 pages

Panasonic SA-XR700 User Manual - Swedish - 144 pages

Panasonic SA-XR700 User Manual - Spanish - 144 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info