734657

Panasonic RC-800 Manual

2
Zoom out
Zoom in
Previous page
1/2
Next page
Time and alarm settings
This is a 24-hour clock.
(Only when the unit is in standby mode)
1 Press and hold [jTIME SET] for at least 2 seconds.
2 Set the time. (Hours and minutes)
≥ Press [HOUR] repeatedly to adjust the hour.
≥ Press [MINUTE] repeatedly to adjust the minute.
3 Press [SNOOZE / BRIGHTNESS / ENTER].
≥ Reset the clock regularly to maintain accuracy.
You can set two alarms with different desired settings.
Preparation
≥ Ensure the time is set.
≥
To set FM as the alarm source, ensure to preset your desired stations to the FM channels.
(Only when the unit is in standby mode)
1 Press and hold [ALARM/jSET, 1] or [ALARM/jSET, 2] for at least 2 seconds.
2 Set the alarm time.
≥ Press [HOUR] repeatedly to adjust the hour.
≥ Press [MINUTE] repeatedly to adjust the minute.
3 Press [SNOOZE / BRIGHTNESS / ENTER] to confirm the alarm time.
4 Press [TUNE / SELECT X, W] to select desired item or setting and then press
[SNOOZE / BRIGHTNESS / ENTER].
≥ Set the audio source.
Source: BUZZ, FM
If FM is set, select a preset station as the audio source.
≥ Set the volume (8 (minimum) to 16 (maximum))
The alarm starts at a low volume and increases gradually to the preset level.
(Volume adjustment made using [VOLUME j, i] will not affect the alarm volume.)
After you complete the alarm setup, the corresponding alarm will be turned on.
Time
Alarm
To check the alarm settings
Press [ALARM/jSET, 1] or [ALARM/jSET, 2] when the unit is in standby mode. (The
alarm time and source will be shown, followed by the alarm volume.)
∫ Turning the alarm on/off
The alarm will sound at the set time every day for a duration of 59 minutes.
You can turn the alarm on/off as desired.
(Only when the unit is in standby mode)
Press [ALARM/
jSET, 1]
or [ALARM/
jSET, 2]
twice to turn the corresponding alarm
on/off.
≥ The corresponding alarm indicator (“ ” or “ ”) will be displayed when its alarm is
turned on.
To stop the sounding alarm
Press [Í/I] or press the corresponding alarm button ([ALARM/jSET, 1] or
[ALARM/jSET, 2]).
To snooze the sounding alarm
Press
[SNOOZE / BRIGHTNESS / ENTER] to put the alarm into snooze mode.
≥ The unit will switch into standby mode and the corresponding alarm indicator (“ ” or “ ”)
blinks slowly.
≥ Snooze interval is 5 minutes.
≥ Press [Í/I] to turn on the unit will also stop the snooze mode.
≥ The alarm works in both unit on and standby modes.
Sleep timer
The sleep timer can turn the unit off after a set time.
Press [SLEEP] repeatedly to select the setting (in minutes).
– OFF, 30, 60, 90, 120
≥ “Zz” is displayed when the sleep timer is set.
≥ To cancel, select “OFF”.
≥ Pressing [SLEEP] while the sleep timer is set allows you to check the remaining time.
Display brightness
Press [SNOOZE / BRIGHTNESS / ENTER] repeatedly to select desired display
brightness (low, medium, high).
≥ You can change the display brightness during unit on or standby mode.
≥ You cannot change the brightness during setting mode or when the alarm sounds.
1
2
1
2
Troubleshooting
Before requesting service, make the following checks. If you are uncertain about some of
the check points, or if the solutions indicated in the following guide does not resolve the
issue, then consult your dealer for instructions.
Sound is distorted or no sound.
≥ Adjust the volume.
≥ If the AC adaptor or fluorescent lights are near the cords, then keep other appliances and cords away
from the cables.
The unit does not work.
≥ One of the unit’s safety devices may have been activated.
1 Press [Í/I] to switch the unit to standby.
≥ If the unit does not turn off, disconnect the AC adaptor from the AC mains socket. After about 30
seconds, reconnect the AC adaptor to the AC mains socket. Then wait for about 10 seconds.
2 Press [Í/I] to switch it on. If the unit still cannot be operated, consult the dealer.
Static or noisy reception is heard while listening to a radio broadcast.
≥ Check and adjust the antenna.
≥ Try to keep a certain amount of distance between the antenna and AC adaptor.
≥ Turn the TV or other audio players off or separate it from this unit.
≥ Keep this unit away from mobile phones if there is interference.
Maintenance
Disconnect the AC adaptor from the outlet before maintenance.
∫ Clean this unit with a soft, dry cloth
≥ When dirt is heavy, wring a wet cloth tightly to wipe the dirt, and then wipe it with a dry cloth.
≥ Never use alcohol, paint thinner or benzine to clean this unit.
≥ Before using chemically treated cloth, carefully read the cloth’s instructions.
∫ To dispose or transfer this unit
The unit may keep the user settings information in the unit. If you discard this unit either by
disposal or transfer, then follow the procedure to return all the settings to the factory defaults to
delete the user settings. (l Troubleshooting, “To return all settings to the factory defaults”)
To return all settings to the factory defaults
Press and hold [Í/I] for at least 10 seconds.
“-- --” appears for about 2 seconds.
≥ The settings are returned to the factory defaults. It is necessary to set the settings again.
General
Radio
Specifications
≥ Specifications are subject to change without notice.
≥ Mass and dimensions are approximate.
≥ Total harmonic distortion is measured by a digital spectrum analyzer.
∫ GENERAL
Power supply
AC adaptor
Input AC 100 V to 240 V, 50/60 Hz, 0.3 A
Output (For Australia and New Zealand) DC 5.0 V, 1.0 A
(For others) DC 5.0 V, 1.0 A, 5.0 W
Main unit
Power supply input
DC IN DC 5 V, 1 A
Power consumption 3W
Power consumption in standby mode
(With display brightness set at medium level) Approx. 0.8 W
Memory backup batteries 3V (2kR6/LR6)
Dimensions (WkHkD) 150 mmk89 mmk90 mm (including protrusions)
Mass
Without batteries Approx. 0.42 kg
With batteries Approx. 0.47 kg
Operating temperature range 0 oC to r40 oC
Operating humidity range 20% to 80% RH (no condensation)
∫ AMPLIFIER SECTION
Output power
RMS output power
Front Ch 1 W Mono (8 ≠), 1 kHz, 10% THD
∫ TUNER SECTION
Preset Memory FM 10 stations
Frequency Modulation (FM)
Frequency range 87.50 MHz to 108.00 MHz (50 kHz step)
∫ SPEAKER SECTION
Speaker unit
Full Range 5cmconetypek1
RC-800_TQBJ2233_eng.fm 2 ページ ２０２０年６月３０日　火曜日　午後３時１０分
2


Need help? Post your question in this forum.

Forumrules
1

Forum

panasonic-rc-800

Reset search

  • How can we change the source for alarm, for example says BUZZ but want FM? Submitted on 30-5-2022 at 13:19

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Panasonic RC-800 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Panasonic RC-800 in the language / languages: English as an attachment in your email.

The manual is 0,72 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Panasonic RC-800

Panasonic RC-800 User Manual - German, Dutch, Danish, French, Italian, Polish, Swedish, Spanish, Norwegian, Finnish - 92 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info