537858
53
Zoom out
Zoom in
Previous page
1/59
Next page
References
ENGLISH
53
Technical Information (continued)
SERIAL TERMINAL
The serial connector which is on the connector panel of the projector conforms to the RS-232C interface
specications. The projector can be controlled by a personal computer which is connected to this connector.
Connection
LAN
SERIAL
COMPUTER 1 IN
S-VIDEO
S-VIDEO
IN
VIDEO IN
AUDIO IN
1
2
AUDIO
OUT
OUT
COMPUTER 2 IN
SERIAL
Pin assignments and signal names
Pin No. Signal name Contents
NC
TXD Transmitted data
RXD Received data
NC
GND Earth
NC
RTS Connected internally
CTS
NC
Communication settings
Signal level RS-232C Character length 8 bits
Sync.method Asynchronous Stop bit 1 bit
Baud rate 9 600 bps X parameter None
Parity None S parameter None
Basic format
:
The data streaming from the computer will start with
STX, and proceed to Command, Parameter and end
with ETX.
You can add the required parameter.
NOTE:
The projector cannot receive any command for 10 seconds after the lamp is switched on. Wait for 10 seconds before sending
the command.
For multiple commands, check the projector if the response has been sent for one command before sending the next
command.
When a command which does not require parameters to be sent, the colon (:) is not required.
If an incorrect command is sent from the personal computer, an ER401 command will be sent from the projector to the
personal computer.
Computer
D-Sub 9-pin (male)
Serial
terminal
(female)
STX Command Parameter ETX
Start byte
(02 h)
1 byte End
(03 h)
3 bytes 1 bytes - 4 bytes
53


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Panasonic PT-LB2E at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Panasonic PT-LB2E in the language / languages: English as an attachment in your email.

The manual is 9,24 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Panasonic PT-LB2E

Panasonic PT-LB2E User Manual - English - 59 pages

Panasonic PT-LB2E User Manual - English - 19 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info