537858
9
Zoom out
Zoom in
Previous page
1/59
Next page
Essential information
ENGLISH
9
Precautions with regard to safety (continued)
ON USE/INSTALLATION
Do not put your weight on this projector.
You could fall or the projector could break, and injury
will result.
Be especially careful not to let young children stand or •
sit on the projector.
Do not place the projector in extremely hot
locations.
Doing so will cause the outer casing or internal
componentstodeteriorate,orresultinre.
Take particular care in locations exposed to direct •
sunlight or near stoves.
Always disconnect all cables before moving the
projector.
Moving the projector with cables still attached can
damagethecables,whichwillcausereorelectric
shocks to occur.
ACCESSORIES
Do not use the old lamp unit.
If used it could cause lamp explosion.
If the lamp has broken, ventilate the room
immediately. Do not touch or bring your face close
to the broken pieces.
Failure to observe this will cause the user to absorb
the gas which was released when the lamp broke and
which contains nearly the same amount of mercury as
uorescentlamps,andthebrokenpieceswillcause
injury.
If you believe that you have absorbed the gas or that
the gas has got into your eyes or mouth, seek medical
advice immediately.
Ask your dealer about replacing the lamp unit and
check the inside of the projector.
CAUTIONS WHEN TRANSPORTING
When transporting the projector, the leg adjusters must
be housed and do not hold them.
When transporting, keep the projector in the
provided carrying bag with the lens cover on it.
Face the lens of the projector in an upward direction •
and put it gently into the carrying bag.
Do not put anything other than the projector and its •
accessories in the carrying bag.
CAUTIONS WHEN INSTALLING
DO NOT USE UNDER THE FOLLOWING
CONDITIONS.
Do not set up the projector outdoors.
The projector is designed for indoor use only.
Avoid setting up in places which are subject to
vibration or shocks.
If the projector is installed in a place where vibrations
are transmitted or mounted in a car or a vessel,
vibrations or impacts will result in damage to the
internal parts, causing failure. Install the product in a
place free from vibrations and impacts.
Avoid setting up in places which are subject to
sudden temperature changes, such as near an air
conditioner or lighting equipment.
Failure to observe this will result in malfunctions or
the lamp life will be shortened.
See “TEMP INDICATOR” on page 45.
Avoid setting up in places which are near high-
voltage power lines or near motors.
The product will be exposed to interference if it is
installed in the vicinity of high-voltage electrical power
lines or power sources.
Do not install the projector at elevations higher
than 2 700 m (8 858 ft) above sea level.
If using this projector at high elevations 1 400 -
2 700 m (4 593 - 8 858 ft) above sea level, set the
HIGH ALTITUDE MODE to ON.
If using this projector at elevations lower than 1 400 m
(4 593 ft) above sea level, set the HIGH ALTITUDE
MODE to OFF.
Failure to observe this will result in malfunctions
or the lamp life or life of other components will be
shortened.
BE SURE TO ASK A SPECIALIZED
TECHNICIAN WHEN INSTALLING THE
PRODUCT TO A CEILING.
If the product is to be installed hanging from the ceiling,
purchase an optional hanging attachment (Model No.
ET-PKB2). Please call a specialized technician or
contact an Authorized Service Center for installation.
LENS FOCUS
Do not adjust the lens focus in the initial period after
switching the projector on. The high clarity projector
lens is thermally affected by the light from the light
source, making the focus unstable in the period just
after switching on. Please allow a warm-up time of at
least 30 minutes before adjusting the lens focus.
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Panasonic PT-LB2E at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Panasonic PT-LB2E in the language / languages: English as an attachment in your email.

The manual is 9,24 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Panasonic PT-LB2E

Panasonic PT-LB2E User Manual - English - 59 pages

Panasonic PT-LB2E User Manual - English - 19 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info