598890
111
Zoom out
Zoom in
Previous page
1/129
Next page
Replacement
ENGLISH -
111
Maintenance
J
Procedure of lamp unit replacement
Attention
When the projector is mounted in the ceiling, do not work directly under the projector or put your face close to the projector.
z
The lamp unit and the lamp unit cover must be attached correctly and securely.
z
If the lamp unit is not installed smoothly, remove it and then install it again. If it is pushed in forcibly, its connector may be
z
broken.
Turn the main power OFF, following the 1 )
procedures described in “Powering off
the projector” (
Æ
page 40), disconnect
the power plug from the AC power
source, and wait for one hour or more.
Then check that the lamp unit has
cooled down.
Turn the “lamp unit cover xing 2 )
screw” (1 piece) with a Phillips-head
screwdriver until it is fully loosened,
and then hold the “lamp unit cover”
securely and open it in the direction of
the arrow.
Use a Phillips screwdriver to loosen 3 )
the “Lamp unit cover xing screw” (4
screws) for the lamp unit to be replaced
until the screws turn freely. Hold the
“Handle” of the “Lamp unit” and
gently pull the lamp unit out from the
projector.
Replace the new LAMP unit in correct 4 )
direction.
Use a Phillips screwdriver to securely 5 )
tighten the 2 “Lamp unit cover xing
screw” for each lamp unit.
Close the “lamp unit cover” and 6 )
tighten the “lamp unit cover xing
screw” (1 piece) securely with a
Phillips-head screwdriver in the
reverse order to Step 2).
Note
When the lamp unit is replaced, the duration of usage
z
time will be reset to “0”.
Lamp unit cover
xing screw
Lamp unit cover
Lamp unit xing screws
Lamp unit 1HandleLamp unit 2
Lamp unit
installation guide
Groove for lamp unit installation guide
Groove for lamp unit installation guide
111


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Panasonic PT-DS8500 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Panasonic PT-DS8500 in the language / languages: English as an attachment in your email.

The manual is 12,55 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info