598890

Panasonic PT-DS8500 Manual

108
Zoom out
Zoom in
Previous page
1/129
Next page
Monitor Lamp indicators
108
- ENGLISH
Maintenance
J
TEMP indicator
Lamp
indication
Information Check point Remedial measure
Lighting in red
Warm-up status
Did you turn on the power when
z
the ambient temperature was
lower than approx. 0 °C (32 °F)?
Wait about 5 minutes in the current
z
status.
Install the unit in a location having
z
an ambient temperature from 0 °C
(32 °F) - 45 °C (113 °F).
High temperature
inside. (WARNING)
Check the ventilation port is
z
blocked.
Is the room air temperature too
z
high?
Is the lter indicator lighted?
z
Remove the object that is blocking
z
the ventilation port.
Move the projector to a temperature
z
of 0 °C (32 °F) - 45 °C (113 °F) and
the humidity of 20 % to 80 % (no
condensation).
Turn off the MAIN POWER switch
z
using the procedure on page 40 and
replace the ACF unit.
Blinking in red
(once)
The lter is
excessively dirty
and the ventilation
is poor.
Blinking in red
(twice)
High temperature
inside.
(Standby condition)
Blinking in red
(3 times)
Cooling fan has
been stopped.
—
Turn off the MAIN POWER switch
z
using the procedure on page 40 and
consult the dealer.
Note
If no problem is found or the problem remains, do not turn on the projector. Instead contact your dealer.
z
J
FILTER indicator
Lamp
indication
Information Check point Remedial measure
Lighting in red
The ACF unit has
run out.
Check the [REMAINING
z
FILTER] of [STATUS] in
[PROJECTOR SETUP] menu.
(
Æ
page 83)
Replace the ACF unit.
z
Blinking in red
The ACF unit is not
installed.
Check the ACF unit
z
compartment.
Replace the ACF unit.
z
Lighting in
orange
The ACF unit
remains few. The
remaining use time
of the ACF unit is
approximately 200
hours.
Check the [REMAINING
z
FILTER] of [STATUS] in
[PROJECTOR SETUP] menu.
(
Æ
page 83)
Request the dealer to purchase the
z
new ACF unit.
Blinking in
orange
The ACF unit cannot
operate properly.
Is foreign object blocking the
z
ACF unit operation?
Remove the foreign object from the
z
ACF unit.
When the foreign object still
z
remained, contact the dealer.
Note
If no problem is found or the problem remains, do not turn on the projector. Instead contact your dealer.
z
When the ACF unit is not installed, the lter indicator will blink in red and the power will turn off in 10 minutes.
z
When the FILTER indicator is ashing green, the Auto Cleaning Filter (ACF) is normally rolling up.
z
When the ACF unit is operating, operational sound may be heard.
z
The usable time after lighting of the orange lamp may be shortened in a dusty environment. The time of about 200 hours is
z
for reference only. Contact the dealer to purchase the new ACF unit earlier.
If the projector is used at elevations higher than 1 400 m above sea level with the [HIGH ALTITUDE MODE] at [OFF], the
z
lamp life or life of other components will be shortened.
Before the FILTER indicator blinks in orange when operational malfunction, mechanical sound of the clutch may be heard.
z
If the Smoke Cut Filter is installed, the green lamp, which takes longer to turn ON/OFF, will ash.
z
If the lter is running low, only one lamp lights even if [DUAL] is selected. The lamps will light as normal once the lter has
z
been replaced and the residual lter has been reset.
… 108 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Panasonic PT-DS8500 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Panasonic PT-DS8500 in the language / languages: English as an attachment in your email.

The manual is 12,55 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info