532618
152
Zoom out
Zoom in
Previous page
1/186
Next page
Maintenance/replacement
152 - ENGLISH
Maintenance
z
When using the replacement lamp unit (for portrait mode), always use it with portrait setting.
Note
z
The model numbers of accessories and optional components are subject to change without notice.
When to replace the lamp unit
The lamp unit is a consumable component. Since its brightness gradually decreases over time, it is necessary
to replace it regularly. The estimated duration before replacement is 2 000 hours. However, this may be
shortened depending on individual lamp characteristics, usage conditions, and the installation environment.
Therefore, it is strongly recommended that a replacement lamp unit be prepared. The unit can damage the
projector if it has not been replaced after 2 000 hours of usage. Thus, the lamp automatically turns off after
approximately ten minutes.
If the cumulative operating time of all 4 lamp unit bulbs exceeds 2 000 hours, the power will be switch off after
about 10 minutes.
On-screen display Lamp indicator
Over 1 800 hours
The message is displayed for 30 seconds.
Pressing any button on the control panel
or remote control within 30 seconds will
clear the message.
Lights in red even during the standby
mode.
Over 2 000 hours
The message remains displayed until you
press a button.
Note
z
To predict when to replace the lamp, check the lamp cumulative operating hours displayed in [LAMP1] - [LAMP4]
(
page 112) of [STATUS].
z
The usage period of 2 000 hours is a rough estimate and is not guaranteed.
z
The guide for replacing the replacement lamp unit (for portrait mode) is 500 hours. The on-screen message for
replacing the lamp appears after 300 hours.
Replacing the lamp unit
Attention
z
When the projector is mounted on the ceiling, do not perform tasks while your face is near the lamp unit.
z
Do not remove or loosen the screws other than specied ones when replacing the lamp.
z
Use the same type of lamp unit for all four lamps.
1) Set the <MAIN POWER> switch to <OFF> and disconnect the power plug from the
power outlet.
z
Wait at least one hour and and check if the lamp unit has cooled down.
2) Remove the lamp unit cover.
(i) Use a Phillips screwdriver to loosen the lamp unit cover xing screw (one screw) counterclockwise until
it turns freely, and then open the lamp unit cover slowly in the direction of the arrow described in the
following gure.

Opening the lamp unit cover quickly may result in damage to the cover.

If you loosen the lamp unit cover xing screw with the projector installed upward in the vertical direction,
the lamp unit cover may open on its weight and drop off the lamp unit.
(ii) Hold the lamp unit cover securely and slide it in the direction of the arrow, and then pull it out backward
to remove.
Lamp unit cover
fixing screw
Lamp unit cover
REPLACE LAMP
152


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Panasonic PT-DS20KU at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Panasonic PT-DS20KU in the language / languages: English as an attachment in your email.

The manual is 18,56 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Panasonic PT-DS20KU

Panasonic PT-DS20KU User Manual - German - 190 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info