543815
86
Zoom out
Zoom in
Previous page
1/104
Next page
Care and replacement
86 -
ENGLISH
Maintenance
Lamp unit replacement procedure
Attention
Once a lamp unit has exceeded its lifespan of 4 000
z
hours (when [LAMP POWER] is set to [NORMAL]) the
projector can only be used for 10 minutes after turning
on. (
page 85)
Perform steps 20) to 23) of the procedure within 10
z
minutes.
If the projector is installed on the ceiling, do not carry out
z
any replacement procedure directly underneath the lamp
unit and keep your face away from the unit.
Do not open the top cover except when replacing the
z
lamp unit.
Do not switch the power on while the top cover is
z
opened.
Always replace the air lter and electrostatic lter
z
whenever replacing the lamp unit.
Install the lamp unit and the lamp cover securely.
z
Press the <OFF> side of the <MAIN 1)
POWER> switch to turn off the power as
described in the “Switching off the power”
procedure (
page 30), remove the power
plug from the power outlet, and then after an
hour or more, check if the area surrounding
the lamp unit has cooled down.
Remove the video cable connected to the 2)
connecting terminal.
Attention
If you open the top panel fully, it may come into contact
z
with connectors such as the video cable which may result
in breakage of the video cable. Before opening the top
panel, be sure to remove the connected video cables,
etc.
Hold the protrusions at the front corner 3)
of the top cover of the projector and
push up to open.
* When the projector is mounted on the ceiling, stand
at the lens side of the projector when opening/
closing the top cover.
Top cover
Protrusion
Attention
Be careful not to open the top panel too far. For what
z
to do if the top panel comes off, see ”Attaching the top
cover” (
page 88).
Use a Philips screwdriver to unscrew 4)
the lamp cover xing screw (one) until
it becomes loose, and then remove the
lamp cover.
* Slowly remove the lamp cover from the projector.
Lamp cover
Lamp
cover fixing
screw
Use a Phillips screwdriver to unscrew the 5)
lamp unit xing screws (2 screws) until
loose.
Hold the handle of the lamp unit and with 6)
the lamp unit
lock held in the direction of
the black arrow, carefully pull it out of the
projector unit in a vertical motion.
Lamp unit fixing
screws
Handle
Lamp unit lock
Replace the new lamp unit while making 7)
sure that the direction of insertion is
correct. Press the top of the lamp unit
downwards and make sure the unit is
installed securely. Tighten the lamp unit
xing screws (2 screws) securely with a
Phillips screwdriver.
Press down on the A part rmly when inserting the
z
lamp unit.
Mount the lamp cover, and tighten the lamp 8)
cover xing screw (one screw) securely with
a Phillips screwdriver.
Close the top cover of the projector.9)
Close the top cover using the reverse of the
z
procedure in 3), and press the center of the top
cover.
Reconnect the video cable disconnected 10)
in 2) to the connecting terminal.
86


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Panasonic PT-AE7000EA at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Panasonic PT-AE7000EA in the language / languages: English as an attachment in your email.

The manual is 17,94 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Panasonic PT-AE7000EA

Panasonic PT-AE7000EA User Manual - French - 104 pages

Panasonic PT-AE7000EA User Manual - Spanish - 104 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info