ENGLISH-21
Getting started
20ENGLISH
Connecting to computer
NOTE:
B Shut down the computer before turning off the MAIN POWER switch of
the projector.
Computer
Computer
To RGB
output
To DVI-D
output
Operating range
If the remote control unit is held so that it is facing directly in front of the
remote control signal receptors on the front or rear of the projector, the
operating range is within approximately 7 m (23´) from the surfaces of the
receptors. Furthermore, the remote control unit can be operated from an
angle of ±30° to the left or right and ±15° above or below the receptors.
# Open the cover.
$ Insert the batteries so that the
polarities are correct, and then close the
cover.
NOTE:
B If there are any obstacles in between the remote control unit and the
receptors, the remote control unit may not operate correctly.
B If strong light is allowed to shine onto the remote control signal receptor,
correct projector operation may not be possible. Place the projector as
far away from light sources as possible.
B
If facing the remote control unit toward the screen to operate the projector,
the operating range of the remote control unit will be limited by the amount
of light reflection loss caused by the characteristics of the screen used.
NOTE:
B Do not drop the remote control unit.
B Keep the remote control unit away from liquids.
B
Remove the batteries if not using the remote control unit for long periods.
B Do not use rechargeable batteries.
Preparation for the remote control unit
AAA batteries
(two)
Equipment such as
an electric screen
