627473
55
Zoom out
Zoom in
Previous page
1/60
Next page
55
When attaching the Filter Kit (VW-LF43WE, optional),
attach it on the inside of the lens hood without removing the
lens hood.
When you want to attach the Tele Conversion Lens
(VW-LT4314ME; optional) or the Wide Conversion Lens
(VW-LW4307ME; optional), be sure to first remove the lens
Hood by turning it counterclockwise.
If you push the [W/T] Lever toward [W] during recording
with the filter or conversion lens attached to the Movie
Camera, 4 corners of the image may become dark
(vignetting). For details, please refer to the operating
instructions of your accessories.
Be sure to keep the Lens Hood attached to the Movie
Camera so as to shut out unnecessary light.
~~~~~~~~~~~~~~~~~~~
Before Requesting Repair (Problems
and Solutions)
Power
1: The Movie Camera power cannot be turned on.
1: Is the power source connected correctly?
(
l
10)
2: The Movie Camera power is turned off
automatically.
2: If you leave the Movie Camera in Recording Pause
Mode for more than 6 minutes, the power is turned off
automatically to protect the tape and to save the Battery
power.
(
l
18)
3: The Movie Camera power does not stay on long
enough.
3-1: Is the Battery low? Charge the Battery or attach a fully
charged Battery.
(
l
10)
3-2: Has condensation occurred? Wait until the
Condensation Indication disappears.
(
l
53)
Battery
1: Battery runs down quickly.
1-1: Is the Battery fully charged? Charge it with the AC
Adaptor.
(
l
10)
1-2: Are you using the Battery in an extremely cold place? In
cold places, the operating time of the Battery becomes
shorter.
(
l
54)
1-3: Has the Battery worn out? If the operating time is still
too short even after the Battery is fully charged, the
Battery has worn out.
2: The Battery cannot be charged.
2: If the DC Input Lead is connected to the AC Adaptor,
charging cannot be performed. Disconnect the DC Input
Lead.
Normal Recording
1: Recording does not start although power is
supplied to the Movie Camera and the Cassette is
correctly inserted.
1-1: Is the accidental erasure prevention slider on the
Cassette open? If it is open (set to [SAVE]), recording
cannot be performed.
(
l
11)
1-2: Is the tape wound to the end? Insert a new Cassette.
(
l
11)
1-3: Is the Movie Camera power turned on?
(
l
18)
1-4: Is the [CAMERA] Lamp on? If the [CAMERA] Lamp is
not on, no recording function can be operated.
(
l
18)
1-5: Has condensation occurred? Wait until the
Condensation Indication disappears.
(
l
53)
Other Recording
1: Auto Focus Function does not work.
1-1: Is Manual Focus Mode selected? If Auto Focus Mode is
selected, focus is automatically adjusted.
(
l
23)
1-2: There are some recording subjects and recording
surroundings for which the Auto Focus Function does
not operate correctly. In this case, use the Manual
Focus Mode to adjust the focus.
(
l
56)
Editing
1: Audio dubbing cannot be performed.
1-1: Is the accidental erasure prevention slider on the
Cassette open? If it is open (set to [SAVE]), recording
cannot be performed.
(
l
11)
1-2: Are you attempting to edit a tape portion that was
recorded in LP Mode? LP Mode does not allow audio
dubbing to operate.
(
l
17)
Indications
1: The Time Code becomes inaccurate.
1: The Time Code Indication counter may not be constant
in the reverse direction in Slow Motion Playback Mode,
but this is not a malfunction.
2: The Remaining Tape Time Indication disappears.
2: When you record still pictures in Photoshot Mode, the
Remaining Tape Time Indication may disappear
temporarily. However, it reappears when recording
normally.
3: The Remaining Tape Time Indication does not
match the actual remaining tape time.
3-1: If scenes of less than 15 seconds are continuously
recorded, the remaining tape time cannot be displayed
correctly.
3-2: In some cases, the Remaining Tape Time Indication
may show remaining tape time that is 2 to 3 minutes
shorter than the actual remaining tape time.
Playback (Images)
1: Images cannot be played back even when the
Operation Lever is pushed towards [
1
].
1: Is the [VCR] Lamp on? If the [VCR] Lamp is not on, the
playback function cannot be used.
(
l
27)
2: Mosaic-pattern noise appears on images during
Cue, Review or Slow Motion Playback.
2: This phenomenon is characteristic of digital video
systems. It is not a malfunction.
3: Although the Movie Camera is correctly connected
to a TV, playback images cannot be seen.
3: Have you selected Video Input on the TV? Please
read the operating instructions of your TV and select the
channel that matches the input sockets used for the
connection.
4: Playback image is not clear.
4: Are the heads of the Movie Camera dirty? If the heads
are dirty, playback image cannot be clear.
(
l
53)
Playback (Sound)
1: Sound is not played back from the built-in speaker
of the Movie Camera or the headphones.
1: Is the volume too low? During playback, keep pressing
the [PUSH] Dial until the [VOLUME] Indication appears.
Then, turn the [PUSH] Dial to adjust the volume.
(
l
27)
2: Different sounds are reproduced at the same time.
2: [12bit AUDIO] on the [PLAYBACK FUNCTIONS]
Sub-Menu of the [VCR FUNCTIONS] Main-Menu has
been set to [MIX]. As a result, the original sound and
sound that was recorded by audio dubbing are played
back together. It is possible to reproduce the sounds
separately.
(
l
32)
3: The original sound was erased when audio dubbing
was performed.
3: If you perform audio dubbing on a recording done in
[16bit] Mode, the original sound will be erased. If you
wish to preserve the original sound, be sure to select
[12bit] Mode at the time of recording.
55


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Panasonic NVMX2B at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Panasonic NVMX2B in the language / languages: English as an attachment in your email.

The manual is 5,02 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info