627445
66
Zoom out
Zoom in
Previous page
1/72
Next page
Others
66
Are you using the Battery in an extremely cold
place? In cold places, the operating time of the
Battery becomes shorter. (
-64-)
Has the Battery worn out? If the operating time
is still too short even after the Battery is fully
charged, the Battery has worn out.
2: The Battery cannot be charged.
If the DC Input Lead is connected to the AC
Adaptor, charging cannot be performed.
Disconnect the DC Input Lead.
Normal Recording
1: Recording does not start although power is
supplied to the Movie Camera and the
Cassette is correctly inserted.
Is the accidental erasure prevention slider on
the Cassette open? If it is open (set to [SAVE]),
recording cannot be performed. (
-11-)
Is the tape wound to the end? Insert a new
Cassette. (
-11-)
Is the Movie Camera power turned on? (
-19-)
Has condensation occurred? Wait until the
Condensation Indication disappears. (
-62-)
Other Recording
1: Auto Focus Function does not work.
Is Manual Focus Mode selected? If Auto Focus
Mode is selected, focus is automatically
adjusted. (
-30-)
There are some recording subjects and
recording surroundings for which the Auto
Focus Function does not operate correctly. In
this case, use the Manual Focus Mode to
adjust the focus. (
-67-)
Editing
1: Audio dubbing cannot be performed.
Is the accidental erasure prevention slider on
the Cassette open? If it is open (set to [SAVE]),
recording cannot be performed. (
-11-)
Are you attempting to edit a tape portion that
was recorded in LP Mode? LP Mode does not
allow audio dubbing to operate. (
-18-)
Indications
1: The Time Code becomes inaccurate.
0 The Time Code Indication counter may not be
constant in the reverse direction in Slow Motion
Playback Mode, but this is not a malfunction.
2: The Remaining Tape Time Indication does
not match the actual remaining tape time.
If scenes of less than 15 seconds are
continuously recorded, the remaining tape time
cannot be displayed correctly.
In some cases, the Remaining Tape Time
Indication may show remaining tape time that
is 2 to 3 minutes shorter than the actual
remaining tape time.
Playback (Pictures)
1: Pictures cannot be played back even when
the [1] Button is pressed.
0 Is the Mode Dial set to Playback Mode? If not,
the playback function cannot be used. (
-36-)
2: Mosaic-pattern noise appears on images
during Cue, Review or Slow Motion
Playback.
This phenomenon is characteristic of digital
video systems. It is not a malfunction.
3: Although the Movie Camera is correctly
connected to a TV, playback images cannot
be seen.
Have you selected “Video Input” on the TV?
Please read the operating instructions of your
TV and select the channel that matches the
input sockets used for the connection.
Depending on your TV, nothing may be shown
even if you correctly connect the Movie
Camera with your TV. In this case, set
[AV JACK] to [OUT].
4: Playback picture is not clear.
Are the heads of the Movie Camera dirty? If the
heads are dirty, playback image cannot be
clear. (
-63-)
5: Playing back or recording do not function,
the screen has frozen or the indication has
disappeared.
Turn the Movie Camera off. If the Movie
Camera is not turned off after operating the
[OFF/ON] switch, press the [RESET] Button
(
-6-) first. And detach the Battery or AC Adaptor
and then reattach it.
Playback (Sound)
1: Sound is not played back from the built-in
speaker of the Movie Camera or the
headphones.
0 Is the volume too low? During playback, push
the [sVOL/JOGr] Lever to display the
[VOLUME] Indication and adjust the volume.
(
-36-)
2: Different sounds are reproduced at the
same time.
[12bit AUDIO] on the [PLAYBACK] Sub-Menu
of the [TAPE PLAYBACK MENU] has been set
to [MIX]. As a result, the original sound and
sound that was recorded by audio dubbing are
played back together. It is possible to
reproduce the sounds separately. (
-45-)
3: The original sound was erased when audio
dubbing was performed.
If you perform audio dubbing on a recording
made in [16bit] Mode, the original sound will be
erased. If you wish to preserve the original
sound, be sure to select [12bit] Mode at the
time of recording.
400GN.book 66 ページ 2004年6月3日 木曜日 午後1時49分
66


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Panasonic NVGS400GN at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Panasonic NVGS400GN in the language / languages: English as an attachment in your email.

The manual is 5,56 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info