627419
42
Zoom out
Zoom in
Previous page
1/52
Next page
Others
42
LSQT1006
Before requesting repair
(Problems and solutions)
Power/Body
1: The movie camera power cannot be turned
on.
Is the battery fully charged? Use a fully
charged battery.
The battery protection circuit may have
operated. Attach the battery to the AC adaptor
for 5 to 10 seconds. If the movie camera still
cannot be used, the battery is faulty.
Is the LCD monitor open or the viewfinder
extend?
2: The movie camera power is turned off
automatically.
If you set [POWER SAVE] to [5 MINUTES] and
do not operate the movie camera for about
5 continuous minutes, the power is
automatically turned off for tape protection and
power conservation. To resume recording, turn
the [OFF/ON] switch to [OFF]. Then turn it to
[ON] again. (
-38-) Also, if you set
[POWER SAVE] to [OFF], the power does not
automatically turn off.
3: The movie camera power does not stay on
long enough.
Is the battery low? If the remaining battery
power indication is flashing or the message
“LOW BATTERY” is displayed, the battery has
run down. Charge the battery or attach a fully
charged battery. (
-8-)
Has condensation occurred? When you carry
the movie camera from a cold place into a
warm place, condensation may occur inside it.
If so, the power is turned off automatically,
disabling all operations except for taking
cassettes out. Wait until the condensation
indication disappears. (
-45-)
4: Battery runs down quickly.
Is the battery fully charged? Charge it with the
AC adaptor. (
-8-)
Are you using the battery in an extremely cold
place? The battery is affected by ambient
temperature. In cold places, the operating time
of the battery becomes shorter.
Has the battery worn out? The battery has a
limited life. If the operating time is still too short
even after the battery is fully charged,
depending on the usage, the battery has worn
out and can no longer be used.
5: The movie camera cannot be operated
though powered up.
The movie camera does not operate
normally.
The movie camera cannot be operated unless
you open the LCD monitor or extend the
viewfinder.
Remove the cassette and then press the
[RESET] button. (
-44-) If normal conditions are
not restored yet, turn off the power. Then,
about 1 minute later, turn on the power again.
6: The cassette cannot be removed.
Does the status indicator comes on when
opening the cassette cover? (
-13-) Make sure
that the battery and the AC adaptor are
properly connected. (
-8-)
Is the battery in use discharged? Charge the
battery and remove the cassette.
Close the cassette cover completely, and fully
open it again. (
-13-)
7: No operation other than cassette removal
can be performed.
Has condensation occurred? Wait until the
condensation indication disappears. (
-45-)
8: The remote control does not function.
(NV-GS37 only)
Has the button-type battery of the remote
control run out? Replace it with a new
button-type battery. (
-18-)
Is the setting on the remote control correct? If
the setting on the remote control is not in
agreement with the [REMOTE] setting on the
movie camera, the remote control does not
operate. (
-19-)
Recording
1: Recording does not start although power is
supplied to the movie camera and the
cassette is correctly inserted.
Is the accidental erasure prevention slider on
the cassette open? If it is open (set to [SAVE]),
recording cannot be performed. (
-13-)
Is the tape wound to the end? Insert a new
cassette.
Is the recording mode set? When in the
playback mode, recording cannot be
performed. (
-21-)
Has condensation occurred? No operation
other than cassette removal can be performed
when condensation occurs. Wait until the
condensation indication disappears. (
-45-)
Is the cassette cover open? If the cover is
open, the movie camera may not operate
normally. Close the cassette cover. (
-13-)
LSQT1006ENG.book 42 ページ 2005年12月9日 金曜日 午前11時17分
42


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Panasonic NVGS27EB at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Panasonic NVGS27EB in the language / languages: English as an attachment in your email.

The manual is 4,3 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Panasonic NVGS27EB

Panasonic NVGS27EB User Manual - English - 20 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info