627412
50
Zoom out
Zoom in
Previous page
1/60
Next page
Others
50
VQT0T85
5: The movie camera cannot be operated
though powered up.
The movie camera does not operate
normally.
Remove the cassette and then press the
[RESET] button. (
-52-) If normal conditions are
not restored yet, turn off the power. Then,
about 1 minute later, turn on the power again.
(Conducting the above operation when the
access lamp is on may destroy the data on the
card.)
6: The cassette cannot be removed.
Does the status indicator comes on when
opening the cassette cover? (
-12-) Make sure
that the battery and the AC adaptor are
properly connected. (
-9-)
Is the battery in use discharged? Charge the
battery and remove the cassette.
Close the cassette cover completely, and fully
open it again. (
-10-)
7: No operation other than cassette removal
can be performed.
Has condensation occurred? Wait until the
condensation indication disappears. (
-53-)
8: The remote control does not function.
Has the button-type battery of the remote
control run out? Replace it with a new
button-type battery. (
-17-)
Is the setting on the remote control correct? If
the setting on the remote control is not in
agreement with the [REMOTE] setting on the
movie camera, the remote control does not
operate. (
-18-)
Recording
1: Recording does not start although power is
supplied to the movie camera and the
cassette is correctly inserted.
Is the accidental erasure prevention slider on
the cassette open? If it is open (set to [SAVE]),
recording cannot be performed. (
-11-)
Is the tape wound to the end? Insert a new
cassette.
Is the recording mode set? When in the
playback mode, recording cannot be
performed. (
-19-)
Has condensation occurred? No operation
other than cassette removal can be performed
when condensation occurs. Wait until the
condensation indication disappears. (
-53-)
Is the cassette cover open? If the cover is
open, the movie camera may not operate
normally. Close the cassette cover. (
-10-)
2: The screen has changed suddenly.
Has the demonstration started? In the Tape
Recording mode, if you set [DEMO MODE] >>
[ON] without inserting a cassette and a card,
the demonstration starts. For normal use, set
this function to [OFF]. (
-45-)
3: A cassette cannot be inserted.
Has condensation occurred? Wait until the
condensation indication disappears.
4: Auto focus function does not work.
Is manual focus mode selected? If auto focus
mode is selected, focus is automatically
adjusted.
There are some recording subjects and
surroundings for which the auto focus does not
operate correctly. (
-57-) If so, use the manual
focus mode to adjust the focus. (
-31-)
Is the colour night view function set? When the
colour night view function is working, focusing
shifts into the manual mode.
Indications
1: A sentence is displayed in red or yellow in
the screen centre.
Read the contents and respond to them. (
-47-)
2: The time code becomes inaccurate.
0 The time code indication counter may not be
constant in the reversed slow-motion playback,
but this is not a malfunction.
3: The remaining tape time indication
disappears.
The remaining tape time indication may
disappear temporarily during frame-by-frame
playback or other operation. If you continue
ordinary recording or playback, the indication is
restored.
4: The remaining tape time Indication does not
match the actual remaining tape time.
If scenes of less than 15 seconds are
continuously recorded, the remaining tape time
cannot be correctly displayed.
In some cases, the remaining tape time
indication may show remaining tape time that is
2 to 3 minutes shorter than the actual
remaining tape time.
5: A function indication such as mode
indication, remaining tape time indication,
or time code indication is not shown.
If you set [SETUP] >> [DISPLAY] >> [OFF],
indications other than the tape running
condition, warning, and date indications
disappear.
VQT0T85ENG.book 50 ページ 2006年12月19日 火曜日 午後2時49分
50


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Panasonic NVGS230EP at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Panasonic NVGS230EP in the language / languages: English as an attachment in your email.

The manual is 4,71 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info