734702
8
Zoom out
Zoom in
Previous page
1/54
Next page
8
9
8
Read carefully and keep for future
reference.
This appliance is supplied with a moulded
three pin mains plug for your safety and
convenience, which may be marked, and
rated 10 amps.
A 10 amp fuse is tted according to the type
of mains plug tted.
Should the fuse need to be replaced, please
ensure that the replacement fuse has the
correct rating for the type of mains plug
tted and that it is approved by ASTA
or BSI to BSI362.
Check for the ASTA mark or the BSI
mark on the body of the fuse.
Warning!
If the fuse cover is detachable,
never use the plug with the cover
omitted. A replacement fuse cover
can be purchased from your local
Panasonic Dealer.
How to replace the fuse
Open the fuse
compartment with
a screwdriver and
replace the fuse.
If the tted moulded plug is unsuitable
for the socket outlet in your home then
the fuse should be removed and the plug
cut off and disposed of safely and an
appropriate one tted. There is a danger
of severe electrical shock if the cut off
plug is inserted into any 10 amp socket.
If a new plug is to be tted, please observe
the wiring code as shown opposite. If in any
doubt, please consult a qualied electrician
(For U.K. Models only).
Warning!
This appliance must be earthed.
Important!
The wires in this mains lead are
coloured in accordance with
the following code: Green-and-
yellow: Earth. Blue: Neutral.
Brown: Live.
As the colours of the wire in the mains
lead of this appliance may not correspond
with the coloured markings identifying the
terminals in your plug, proceed as follows:
The wire which is coloured green-and-
yellow must be connected to the terminal in
the plug which is marked with the letter E or
by the Earth symbol or coloured green
or green-and-yellow.
The wire which is coloured blue must be
connected to the terminal in the plug which
is marked with the letter N or coloured
black.
The wire which is coloured brown must be
connected to the terminal in the plug which
is marked with the letter L or coloured red.
When this oven is installed it should be easy
to isolate the appliance from the electricity
supply by pulling out the plug or operating a
circuit breaker.
Voltage & Power
The voltage used must be the same
as specied on this microwave oven.
Using a higher voltage than that
which is specied is dangerous and
may result in a re or other type of
accident causing damage.
Do not immerse cord, plug or oven in water.
Keep cord away from heated surfaces. Do not
let cord hang over the edge of table or work
top. Do not plug your oven in via an extension
cable as this can be dangerous. It is important
to plug the oven directly into a wall socket.
The back of the appliance heats up during
use. Do not allow the cord to be in contact
with the back of the appliance or cabinet
surface.
Safety Instructions
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Panasonic NN-SD26HM at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Panasonic NN-SD26HM in the language / languages: English as an attachment in your email.

The manual is 4,95 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info