575327
18
Zoom out
Zoom in
Previous page
1/24
Next page
34 3535
Troubleshooting
Problem Cause and Measures
Rinse/Spin
Water is not
supplied to the
drum during the
rinse process
- Before rinsing, the appliance spins to drain out any
remaining water. Then it lls up with fresh water.
Rinsing begins
before the spin
process nishes
- If the appliance detects an unbalanced load, it
automatically starts rinsing to correct the imbalance.
- If excess foam remains after washing, the water is
drained out and relled to wash the foam away. This is 
the foam detection function.
During the spin
process, the drum
stops and rotates
several times
- This is normal. When the appliance detects an
unbalanced load, it automatically tries to correct it.
- The laundry may be too light.
¦Try adding one or two bath towels.
Foam or water
remains on the
door or door seal
- Some foam or water may remain depending on the
state of the laundry or the amount of detergent used.
Wipe foam or water away before taking out the laundry.
Laundry clings to
the drum
- If the “Eco” or “Speed” function is used when there is a
lot of laundry, the laundry may cling to the drum.
Time
The displayed
remaining time
changes
- The display is only a guide and is corrected continually.
- The remaining time may increase if the rinse or spin
settings are changed or if the appliance detects an
unbalanced load and makes an adjustment accordingly.
- Remaining time may be longer or shorter while
operating with the “AutoCare” programme.
Detergent and foam
There is not
enough/too much
foam
- The amount of foam varies depending on the
temperature, level and softness of the water.
The following can result in less foam
- Powdered detergent may have been put directly into
the drum.
¦It should be put into the detergent drawer. (P. 12)
- Too little detergent may have been used.
- The laundry may be heavily soiled.
- The load may be large.
The following can result in more foam
- Too much detergent may have been used.
Problem Cause and Measures
Detergent and foam
Fabric softener
overows
- The amount of softener used may have been above the
“MAX” line in the detergent drawer. (P. 12)
- The detergent drawer may have been closed too
strongly and spilt some of the softener.
There is powdered
detergent left on
the laundry after
washing
- Powdered detergent may have been put directly into
the drum.
¦It should be put into the detergent drawer. (P. 12)
Noise
There is an
unusual noise or
vibration
- There may be a metal item in the drum.
- The anchor rods may not have been removed.
( P. 38)
- The appliance may be installed on a slope or an
unstable surface.
If none of the above is the cause, contact your local
Customer Service Centre.
There is noise
when water drains
out
- This is normal. It is the noise of the drain pump
working.
Others
There is a power
cut during
operation
- When power is restored, start operation of the
appliance from the beginning.
The circuit breaker
trips during
operation
- Find and resolve the issue that caused the breaker to
trip. Then reset the breaker and start operation of the
appliance from the beginning.
The water supply
is disrupted
- After the water supply is restored, the water may be
discoloured for a short while.
¦ Disconnect the water supply hose, run the tap until
the water is no longer discoloured, and reconnect the
water supply hose. (P. 41)
The display is
unclear
- The appliance may be in a brightly lit or sunlit area.
Troubleshooting (continued)
18


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Panasonic NA-148XS1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Panasonic NA-148XS1 in the language / languages: English as an attachment in your email.

The manual is 10,03 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Panasonic NA-148XS1

Panasonic NA-148XS1 User Manual - German - 24 pages

Panasonic NA-148XS1 User Manual - Dutch - 24 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info