608253

Panasonic MW20GN Manual

25
Zoom out
Zoom in
Previous page
1/28
Next page
25
VQT2Z88
Reference
Using in a wall-mounted state / Maintenance
Maintenance
Unplug the AC adaptor from the household mains socket
and wipe it using a soft and dry cloth.
When the dirt is heavy, wring water out of a wet cloth to
wipe the dirt and then wipe with a dry cloth.
Do not use solvents including benzine, thinner, alcohol,
kitchen detergent, etc. This might cause the exterior case
to be deformed or the coating to come off.
Before using chemically treated cloth, read the instructions
that come with the cloth carefully.
Information for Users on Collection and Disposal of
Old Equipment and used Batteries
These symbols on the products, packaging,
and/or accompanying documents mean that
used electrical and electronic products and
batteries should not be mixed with general
household waste.
For proper treatment, recovery and
recycling of old products and used
batteries, please take them to applicable
collection points, in accordance with your
national legislation and the Directives
2002/96/EC and 2006/66/EC.
By disposing of these products and
batteries correctly, you will help to save
valuable resources and prevent any
potential negative effects on human health
and the environment which could otherwise
arise from inappropriate waste handling.
For more information about collection and
recycling of old products and batteries,
please contact your local municipality, your
waste disposal service or the point of sale
where you purchased the items.
Penalties may be applicable for incorrect
disposal of this waste, in accordance with
national legislation.
For business users in the European
Union
If you wish to discard electrical and
electronic equipment, please contact your
dealer or supplier for further information.
[Information on Disposal in other
Countries outside the European Union]
These symbols are only valid in the
European Union. If you wish to discard
these items, please contact your local
authorities or dealer and ask for the correct
method of disposal.
Cd
Note for the battery symbol (bottom two
symbol examples):
This symbol might be used in combination
with a chemical symbol. In this case it
complies with the requirement set by the
Directive for the chemical involved.
•
•
•
Safety cautions
WARNING!
Only a qualifi ed building contractor shall install or
uninstall this unit.
Improper installation may cause the unit to fall, resulting in
injury.
To prevent injury, the unit must be securely attached
to the wall in accordance with the installation
instructions.
Do not install the unit where it cannot support the load.
If the mounting parts are not strong enough, this may
cause the unit to fall, resulting in injury.
Do not use installation methods other than instructed.
This may cause the unit to fall and be damaged, resulting
in injury.
Do not install the unit at locations other than vertical
walls.
This may cause the unit to fall and be damaged, resulting
in injury.
Take the safety factor for mounting strength into
account (approx. 10 times the product weight).
Insuffi cient strength will cause the unit to fall, resulting in
injury.
The wall on which the unit is to be attached to should
be capable of supporting 5 kg per screw.
Insuffi cient strength of the walls will cause the unit to fall in
the long run.
Do not disassemble or modify the wall-mounting hanger.
This will cause the unit to fall and be damaged, resulting
in injury.
CAUTION!
Do not install this unit at humid or dusty locations, or
locations where airborne grease or steam may come
into contact with the unit, or under an air conditioner
where water may drip onto the unit.
This may have negative impact on the unit, resulting in fi re
or electric shock.
Secure enough space of more than 25.4 mm above the
main unit and more than 25.4 mm on the left and right
sides respectively. Keep space between the wall and
rear of the unit clear of obstructions.
Blocking the exhaust holes on the main unit may result in
fi re.
Use the designated components for installation.
Otherwise, the main unit may fall and be damaged,
resulting in injury.
Prevent the mounting screws or power cord from
coming into contact with metal parts inside the wall
during installation.
Failure to do so may cause electric shock.
When removing the main unit, remove the wall
mounting screws as well.
Otherwise the wall mounting screws may hit a person and
lead to injury.
Install the unit at a height where the SD card slot can
be seen for safe operation.
Operating at improper position may cause the unit to fall
and be damaged, resulting in injury.
… 25 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Panasonic MW20GN at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Panasonic MW20GN in the language / languages: English as an attachment in your email.

The manual is 2,78 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info