619940
27
Zoom out
Zoom in
Previous page
1/48
Next page
Programming
27
Erasing a number:
W i {V}/{^}: Yes i M i {b}
1 8 (middle soft key)
2 {V}/{^}: Caller Barred i M
3 {V}/{^}: Select the desired entry.
L To exit, press {ih}.
4 Proceed with the desired operation.
Editing a number:
8 i {V}/{^}: Edit i M i Edit
the phone number. i M i {ih}
Erasing a number:
W i {V}/{^}: Yes i M i
{ih}
Note for base unit and handset:
L When editing, press the desired dial key to add,
^ to erase.
Registering a unit
Operating additional units
Additional handsets
Up to 6 handsets can be registered to the base
unit.
Important:
L The additional handset model recommended for
use with this unit is noted on page 4. If another
handset model is used, certain operations (base
unit settings, handset settings, etc.) may not be
available.
Registering a handset to the base
unit
The supplied handset and base unit are pre-
registered. If for some reason the handset is not
registered to the base unit (for example, w flashes
even when the handset is near the base unit), re-
register the handset.
1 Handset:
8 (middle soft key)
2 {V}/{^}: Handset Setup i M
3 {V}/{^}: Register H.set i M
4 Base unit:
Press and hold {x} for about 5 seconds, until
the registration tone sounds.
L If all registered handsets start ringing, press
the same button to stop. Then repeat this
step.
L The next step must be completed within 90
seconds.
5 Handset:
Wait until Base PIN is displayed. i Enter
the base unit PIN (default: 0000). i M
L If you forget your PIN, contact an authorised
service centre.
L When the handset has been registered
successfully, w stops flashing.
Note:
L When you purchase an additional handset, refer
to the additional handset’s installation manual
for registration.
Deregistering a handset
A handset can cancel its own registration (or the
registration of another handset) that is stored to
the base unit. This allows the handset to end its
wireless connection with the system.
1 8 (middle soft key)
2 {V}/{^}: Base Unit Setup i M
3 {3}{3}{5}
4 {V}/{^}: Cancel Register i M
L The numbers of all handsets registered to
the base unit are displayed.
5 Select the handset(s) you want to cancel by
pressing the desired handset number. i
M
L The selected handset number(s) flashes.
L To cancel a selected handset number,
press the number again. The number stops
flashing.
6 {V}/{^}: Yes i M
L A confirmation tone sounds as each
handset number disappears.
L The handset does not beep when
cancelling its own registration.
7 {ih}
Y Handset
Y Handset
TG6451_6461FX(e-e).book Page 27 Monday, May 4, 2009 8:55 AM
27


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Panasonic KX-TG6451 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Panasonic KX-TG6451 in the language / languages: English as an attachment in your email.

The manual is 3,31 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info