2 Select your desired categories by
pressing 1 to 9.
R “
” is displayed next to the selected
category numbers.
R To cancel a selected category, press
the same dial key again. “
”
disappears.
3 MOKN a M N
Incoming call barring
This feature allows the unit to reject calls from
specified phone numbers that you do not want
to answer such as junk calls.
When a call is received, the unit does not ring
while the caller is being identified. If the phone
number matches an entry in the call barred
list, the unit emits no sound to the caller, and
disconnects the call. (Caller ID subscribers
only)
Important:
R When the unit receives a call from a
number that is stored in the call barred list,
the call is logged in the caller list
(page 35) with
after the call is
disconnected.
Storing unwanted callers
You can store up to 100 phone numbers in the
call barred list.
Important:
R You must store the phone number with an
area code in the call barred list.
n From the caller list:
1 M
N
2 MbN: Select the entry to be barred. a
MDetailN a MMenuN
3 MbN: “Save CID” a MOKN
4 MbN: “Caller Barred” a MOKN
5 MbN: “Yes” a MOKN a M N
n By entering phone numbers:
1 MMenuN (right soft key) #217 a
MAddN
2 Enter the phone number (24 digits
max.). a MOKN
3 M
N
Viewing/editing/erasing bar call
numbers
1 MMenuN (right soft key) #217
2 MbN: Select the desired entry.
R To exit, press M
N.
3 To edit a number:
MEditN a Edit the phone number. a
MOKN a M
N
To erase a number:
MEraseN a MbN: “Yes” a MOKN a
M
N
Baby monitor
This feature allows you to listen in on a room
where another handset is located, allowing
you to easily monitor from different areas of
the house or place. The monitored handset
(placed in a baby’s room, for example) will
automatically call the monitoring handset or
the phone number stored when it detects
sound.
Important:
R You should perform a test run of the baby
monitor procedure to ensure that the baby
monitor feature is set correctly. For
example, test its sensitivity. Check the
connection if you are diverting the baby
monitor to an outside line.
Note:
R Both the monitored and monitoring
handsets must select the same base unit in
order to use the baby monitor feature
(page 33).
R If the unit is connected to a PBX system,
you cannot set the baby monitor.
R During the monitoring mode, battery
consumption is faster than usual. We
recommend leaving the monitored handset
on the base unit or charger.
R The monitored handset never rings during
the monitoring mode.
29
Programming
