R I
f all registered handsets start ringing,
press M
N
again to stop, then repeat
this step.
4 Handset:
MOKN a Wait until “Base PIN” is
displayed. a Enter the base unit PIN
(default: “0000”). a MOKN
R If you forget your PIN, contact an
authorised service centre.
Selecting a base unit
W
hen “Auto” is selected, the handset
automatically uses any available base unit it is
registered to. When a specific base unit is
selected, the handset makes and receives
calls using that base unit only. If the handset is
out of range of that base unit, no calls can be
made.
1 MMenuN (right soft key) #137
2 MbN: Select the desired base unit number,
or “Auto”. a MOKN
Deregistering a handset
A
handset can cancel its own registration to
the base unit, or other handsets registered to
the same base unit. This allows the handset to
end its wireless connection with the system.
1 MMenuN (right soft key) #131
R All handsets registered to the base unit
are displayed.
2 MbN: Select the handset you want to
cancel. a MOKN
3 MbN: “Yes” a MOKN
4 M
N
Cancelling a base unit
A
handset can cancel a base unit that it is
registered to. This allows the base unit to end
its wireless connection with the system.
1 MMenuN (right soft key) #139
2 MbN: Select the base unit you want to
cancel. a MOKN
3 MbN: “Yes” a MOKN a M
N
Increasing the range of the base
unit
You can increase the signal range of the base
unit by using a DECT repeater. Please use
only the Panasonic DECT repeater noted on
page 3. Contact your Panasonic dealer for
details.
Important:
R Before registering the DECT repeater to
this base unit, you must turn the DECT
repeater mode on.
R Do not use more than one DECT repeater
at a time.
Setting the DECT repeater mode
1 MM
enuN (right soft key) #138
2 MbN: Select the desired setting. a MOKN
a M
N
Registering the DECT repeater
(
KX-A405) to the base unit
Note:
R Please use a DECT repeater that has not
yet been registered to another unit. If the
DECT repeater is registered to another unit,
deregister it first, referring to the Installation
Guide for the DECT repeater.
1 Base unit:
Press and hold M
N
for about 5 seconds.
2 DECT repeater:
Connect the AC adaptor, then wait until
the
indicator and indicator light
g
reen.
3 Base unit:
To exit the registration mode, press M
N.
32
Programming
