628745
125
Zoom out
Zoom in
Previous page
1/142
Next page
5.1.3 Operation
PROBLEM PROBABLE CAUSE SOLUTION
Cannot set the IP
address, subnet mask
address, and PBX IP
address to the IP-PT.
An unusable value is
being set.
Set an IP address within the valid range.
IP address of the IP-PT/PBX: "1.0.0.0" to
"223.255.255.255
" Subnet mask address:
"0–255.0–255.0–255.0–255" (except
0.0.0.0 and 255.255.255.255)
Cannot register the
IP-PT.
The necessary network
parameters are not set
to the IP-PT.
When
not using a DHCP server, set the IP
address, subnet mask address, and enter
the PBX IP address. If necessary, also
enter the IP address of the default
gateway.
When using a DHCP server, enter the
PBX IP address.
The IP-PT cannot
connect to the PBX.
The wrong IP address,
subnet mask address,
PBX IP address, or
default gateway
address was entered.
Check each parameter and enter the
correct value.
The Ethernet cable is
not connected
correctly.
Check the Ethernet cable connections.
The
DHCP server is not
active.
Restart the DHCP server.
Disable DHCP and re-enter settings as
appropriate.
Whenever you try to
make calls using a SIP
Extension, a busy tone
is heard.
The status of the port
that the SIP Extension
is
connected to is Out of
Service.
Change the port status from Out of
Service to In Service using the
Maintenance Console.
When using the
speakerphone on an
APT,
nothing is audible.
The HANDSET/
HEADSET selector is
set to the "HEADSET"
position.
When the headset is not used, set the
HANDSET/HEADSET selector to the
"HANDSET" position.
When using the
speakerphone/monitor
mode with a DPT,
nothing is audible.
The "HEADSET" mode
is selected by Personal
Programming,
"Handset/Headset
Selection".
When the headset is not used, select the
"HANDSET" mode by Personal
Programming.
The PT does not ring. The
ringer volume is off. Turn on the ringer volume.
During a power failure,
extensions connected
to
port 1 of DHLC4 card
do not operate.
A DPT or APT is
connected to the
extension port.
The dialing mode (tone
or pulse) is incorrect.
Disconnect the DPT or APT and connect
an SLT.
Set the Tone/Pulse switch to the other
position.
Document Version 2011-10 Installation Manual 125
5.1.3 Operation
125


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Panasonic KX-NCP500 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Panasonic KX-NCP500 in the language / languages: English as an attachment in your email.

The manual is 2,93 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Panasonic KX-NCP500

Panasonic KX-NCP500 User Manual - English - 218 pages

Panasonic KX-NCP500 User Manual - German - 286 pages

Panasonic KX-NCP500 User Manual - Dutch - 286 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info