Installation
The main unit is installed on a wall, and the probe unit can be installed on a wall or
a floor.
When the metal probes on the probe unit come in to contact with water, a small
amount of electrical charge flows between the probes, which the main unit
recognizes as a water leak.
Probe unit installed on wall Probe unit installed on floor
Installation precautions
R T
he sensor is not designed to be used in situations that require high reliability.
We do not recommend use of the sensor in these situations.
R Panasonic takes no responsibility for any injury or damage caused by the use of
this product.
R When installing, make sure the battery is inserted properly and the main unit
cover is completely closed.
R When installing on a wooden surface, use the included wall mounting adaptors.
Secure the wall mounting adaptors to the wall using screws (not double-sided
tape).
R Mount the sensor on the stable location where the sensor can be adequately
supported when mounting.
R Do not mount the sensor on a soft material. It may fall down, break or cause
injury.
R Do not mount the sensor on the following places: gypsum board, ALC
(autoclaved lightweight cellular concrete), concrete block, plywood less than
25.4 mm (1 inch) thick, etc.
R The sensor may not be able to properly detect a water leak if the water contains
contaminants such as oil, or if the water is frozen (i.e., ice or snow).
For a
ssistance, please visit http://shop.panasonic.com/support
11
Setup
